ASRock H510M-HDV - Инструкция по эксплуатации - Страница 23

English

19

H510M-HDV R2.0

H510M-HVS R2.0

Chassis/Water Pump Fan 
Connector
(4-pin CHA_FAN1/WP)
(see p.1, 2, No. 4)

This motherboard  
provides a 4-Pin water 
cooling chassis fan 
connector. If you plan to 
connect a 3-Pin chassis 
water cooler fan, please 
connect it to Pin 1-3.

CPU Fan Connector
(4-pin CPU_FAN1)
(see p.1, 2, No. 2)

This motherboard pro-
vides a 4-Pin CPU fan 
(Quiet Fan) connector. 
If you plan to connect a 
3-Pin CPU fan, please 
connect it to Pin 1-3.

ATX Power Connector
(24-pin ATXPWR1)
(see p.1, 2, No. 5)

This motherboard pro-
vides a 24-pin ATX power 
connector.

1    2    3    4

GN D

CHA_FAN_SPEED

FAN_SPEED_CONTRO L

FAN_VOLTAGE

12

 1

24

13

4   3   2   1

G N D

+ 1 2 V

C P U _ FA N _ S P E E D

FA N _ S P E E D _ C O N T R O L

1.  High Definition Audio supports Jack Sensing, but the panel wire on the chassis 

must support HDA to function correctly. Please follow the instructions in our 
manual and chassis manual to install your system.

2.  If you use an AC’97 audio panel, please install it to the front panel audio header by 

the steps below: 
A. Connect Mic_IN (MIC) to MIC2_L. 
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L. 
C. Connect Ground (GND) to Ground (GND). 
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to 
connect them for the AC’97 audio panel. 
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel 
and adjust “Recording Volume”.