ASRock B760 - Инструкция по эксплуатации - Страница 56

Version 1.0 
Published November 2022

Copyright©2022 ASRock INC. All rights reserved.

Copyright Notice:

No part of this documentation may be reproduced, transcribed, transmitted, or 

translated in any language, in any form or by any means, except duplication of 

documentation by the purchaser for backup purpose, without written consent of 

ASRock Inc.
Products and corporate names appearing in this documentation may or may not 

be registered trademarks or copyrights of their respective companies, and are used 

only for identification or explanation and to the owners’ benefit, without intent to 
infringe.

Disclaimer:

Specifications and information contained in this documentation are furnished for 

informational use only and subject to change without notice, and should not be 

constructed as a commitment by ASRock. ASRock assumes no responsibility for 

any errors or omissions that may appear in this documentation.  
With respect to the contents of this documentation, ASRock does not provide 

warranty of any kind, either expressed or implied, including but not limited to 

the implied warranties or conditions of merchantability or fitness for a particular 

purpose.
In no event shall ASRock, its directors, officers, employees, or agents be liable for 

any indirect, special, incidental, or consequential damages (including damages for 

loss of profits, loss of business, loss of data, interruption of business and the like), 

even if ASRock has been advised of the possibility of such damages arising from any 

defect or error in the documentation or product.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions: 

(1)  this device may not cause harmful interference, and 

(2)  this device must accept any interference received, including interference that  

may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the following 

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.