Машинки для стрижки Saturn ST-HC0360 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
7
between the comb/fingers and the
head. Comb out trimmed hair and
check for uneven strands.
STEP 5 - THE FINISHING TOUCH
1.
Finally, use the taper lever without
an attachment comb for close trimming
around the base of the neck, the sides
of the neck and the ears.
2.
Press the clipper at right angles to
the head, tips of the blades lightly
touching
the
skin
and
work
downwards. This way you will obtain a
clean cut, as it would be given by a
razor.
SHORT TAPERED STYLES - 'FLAT
TOPS' AND SHORT CUTS
1.
Starting
with
the
longest
attachment comb (12mm), cut from
the back of the neck to the crown. Hold
the attachment comb flat against the
head and slowly move the clipper
through the hair, as shown (see
diagram 8).
2.
Use the same procedure from the
lower side to the upper side of the
head, as illustrated. Then cut the hair
against the direction, in which it grows,
from the front to the crown and then
level the cut with the sides.
3.
To give a flat top look, the hair on
top of the head must be cut over the
top of a flat comb rather than by using
the attachment comb.
4.
Use closer cutting attachment
combs to taper the hair down to the
neckline as desired. Comb hair and
check for uneven areas and outlining
sideburns and neckline, as described
previously.
Specification:
Power:
12 W
Rated voltage:
220-240 V
Rated frequency:
50 Hz
Rated current:
0.05 А
Accessories:
4 attached
combs, clean brush, scissors, hair
comb, oil.
Set:
HAIR CLIPPER
1
INSTRUCTION MANUAL WITH
WARRANTY BOOK
1
PACKAGE
1
ENVIRONMENT FRIENDLY DISPOSAL
You can help protect the
environment!
Please
remember to respect the
local regulations: hand in
the
non-working
electrical equipment to an
appropriate
waste
disposal center.
The manufacturer reserves the
right to change the specification
and design of goods.
