Remington MB7050 T - Инструкция по эксплуатации - Страница 6

6

• 

Hair should be dry and free from any waxes or lotions.

• 

If hair builds up during use, switch the unit off, remove any attachment in use and 

clean any excess hair clippings from the attachment and groomer. 

ON/OFF/TURBO MODE

• 

Switch the trimmer on  by pressing the On/Off/Turbo switch once for normal mode, 

again for Turbo mode and a third time to turn the trimmer off.

• 

Turbo mode is for thicker beards or heavier areas of facial hair and provides a boost in 

power.

BEARD STYLING AND MAINTENANCE

• 

Attach the adjustable stubble comb or a fixed guide comb to the T-blade. If you are 

trimming for the first time start with the maximum trimming length setting.

• 

Turn the unit on.

• 

Start trimming under the chin following the line of the jaw.

• 

Place the flat top of the trimmer comb against the skin.

• 

Slowly slide through the hair. Work upwards towards the ear and upper beard line. 

Repeat from different directions as necessary.

• 

Tidy the beard edges using the T-blade. Use slow controlled movements to create 

contoured lines.

• 

If hair builds up in the trimmer comb during the trimmer process, switch the unit off, 

pull the comb and brush the hair off.

HAIR CLIPPING

Step 1: Nape of the neck 

1.  Attach the 3mm or 6mm fixed comb.

2.  Hold the trimmer with the blade teeth pointing upwards. Start at the centre of the 

head at the base of the neck.

3.  Slowly lift the trimmer, working upwards and outwards through the hair trimming just 

a little at a time.

Step 2: Back of the head

• 

With the 12mm or 18mm guide comb attached, cut the hair at the back of the head.

Step 3: Side of the head

• 

With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the 

longer 9mm or 12mm guide comb and continue to cut the top of the head.

Step 4: Top of the head

• 

Use the longer length fixed combs of 18mm or 25mm to cut hair on top of the head 

against the direction in which the hair normally grows.

• 

Always work from the back of the head.

Step 5: The finishing touches

• 

Use the trimmer without a comb for close trimming around the base and sides of the 

neck.

ENGLISH