BRAYER BR3402 - Инструкция по эксплуатации - Страница 8

8

EN

HAIR STYLING INSTRUCTIONS 

•  Before cutting hair switch the hair clipper on and 

make sure that hair clipper operates normally and the 

blades move smoothly. If there is excess oil on the 

blades (6), wipe it with a paper towel or a dry cloth. 

•  Seat the person whose hair you cut so that his/her 

head is approximately at your chest level.

•  For the best results, cut dry hair. Do not cut

•  freshly washed hair, dry them with a towel and blow 

dry.

•  Comb the hair along the direction of hair growth.

•  Always move the hair clipper against the direction of 

the hair growth. You can cut hair along the direction 

of hair growth, but keep in mind that the hair cut 

against the growth will be shorter than the hair cut 

along the growth. 

•  Move the hair clipper slowly during cutting hair.

USING THE ATTACHMENT COMBS

•  The hair clipper set includes the attachment combs 

(10, 11, 12, 13) intended for various remaining hair 

length:

 - (10) — 3 mm

 - (11) — 6 mm

 - (12) — 9 mm

 - (13) — 12 mm

•  To learn your hair clipper, start cutting hair with the 

attachment comb with a maximum remaining hair 

length (13) — 12 mm.

•  To remove the blade block place the hair clipper with 

the blades towards you and press on the upper edge 

of the blade block (6) with your thumb (pic. 6). 

•  Apply the lubricating oil (14) to the junctions between 

the fixed and moving parts of the blades (pic. 2). 

• 

Install the blade block (6) back to its place. To do this, 

first insert its lower part to the installation place and 

then press on the upper edge of the blade block (6). 

Make sure that the blade block (6) is installed and 

fixed properly (pic. 9). 

•  Switch the hair clipper on by moving the switch (5) to 

the position «I» and let it operate for approximately 

30 seconds to spread the oil across the rubbing 

surfaces of the blades.

• 

Switch the hair clipper off by moving the switch (5) to 

the position «0» and remove the excessive oil with a 

paper towel or a dry cloth.

INSTALLING AND REMOVING THE 

ATTACHMENT COMB

• 

Install the attachment comb (10, 11, 12 or 13) on the 

blade block (6) (pic. 3). 

•  To remove the attachment comb (10, 11, 12 or 

13) press on the lower part of the attachment and 

remove it from the hair clipper body (pic. 4). 

• 

Notes:

 — without using the attachment combs (10, 

11, 12 or 13), for a short haircut, you can change the 

remaining hair length in the range from 0.8 mm to 

2 mm, to change the remaining hair length turn the 

lower part of the hair clipper body (4) (pic. 5).