BRAYER BR3400 - Инструкция по эксплуатации - Страница 9

9

EN

•  Always move the hair clipper against the direction of 

the hair growth. You can cut hair along the direction 

of hair growth, but keep in mind that the hair cut 

against the growth will be shorter than the hair cut 

along the growth. 

•  Move the hair clipper slowly during cutting hair.

USING THE ATTACHMENT COMBS

•  The hair clipper set includes the attachment combs 

(10, 11, 12, 13) intended for various remaining hair 

length:

 - (10) — 3 mm

 - (11) — 6 mm

 - (12) — 9 mm

 - (13) — 12 mm

•  To learn your hair clipper, start cutting hair with the 

attachment comb with a maximum remaining hair 

length (13) — 12 mm.

•  After learning the hair clipper better you will be able 

to use the attachment combs which leave shorter 

hair.

• 

For even haircut make sure that the attachment 

comb fits closely to the head.

•  Slowly run the hair clipper through the hair, moving it 

in different directions, make overlapping movements 

to make sure that all areas of the hair on the head 

are trimmed.

•  Comb the hair along the direction of the growth to 

make it easier to cut them with the clipper.

•  For even haircut of wavy, thin or long hair, use the 

comb to direct the hair to the blade block (6).

•  From time to time clean the attachment comb from 

cut hair with the brush (15).

STEP ONE 

•  Install the attachment comb (11 or 12). Switch the 

hair clipper on by pressing the button (5) «   ». Hold 

the hair clipper with the blades pointed upwards. 

Start cutting from the hair growth edge. Slowly move 

the hair clipper upwards. Cut the back of the head 

area at the bottom and near the ears. 

• 

Notes:

 - to cut hair faster, switch the turbo mode on. To do 

this, press the button (5) «   », the symbol  

(2) «   » will light up;

 - if the battery runs low during hair cutting and 

the symbol (7) «   » lights up, use the power 

adapter; 

 -

insert the power adapter (9) jack into the socket on 

the hair clipper body (pic. 1);

 - connect the power adapter (9) to the mains, the 

charging level digital symbols (3) and the symbol 

(7) «   » will light up;

 - wait for 2-3 minutes, switch the hair clipper on and 

continue cutting hair;

 -

during the breaks between operation or to avoid 

accidental switching on use the locking mode. To 

switch the locking mode on press and hold the