BRAYER BR3400 - Инструкция по эксплуатации - Страница 8

8

EN

up. To switch the lock mode off press again and hold 

the button (5) «   » for 5 seconds, the symbol  

(8) «   » will go out. 

INSTALLING AND REMOVING THE 

ATTACHMENT COMB

•  Install the attachment comb (10, 11, 12 or 13) on the 

blade block (6) (pic. 3). 

•  To remove the attachment comb (10, 11, 12 or 

13) press on the lower part of the attachment and 

remove it from the hair clipper body (pic. 4). 

• 

Notes:

 — without using the attachment combs (10, 

11, 12 or 13), for a short haircut, you can change the 

remaining hair length in the range from 0.8 mm to 

2 mm, to change the remaining hair length turn the 

lower part of the hair clipper body (4) (pic. 5).

HAIR STYLING INSTRUCTIONS 

•  Before cutting hair switch the hair clipper on and 

make sure that hair clipper operates normally and the 

blades move smoothly. If there is excess oil on the 

blades (6), wipe it with a paper towel or a dry cloth. 

•  Seat the person whose hair you cut so that his/her 

head is approximately at your chest level.

•  For the best results, cut dry hair. Do not cut

•  freshly washed hair, dry them with a towel and blow 

dry.

•  Comb the hair along the direction of hair growth.

• 

To remove the blade block place the hair clipper with 

the blades towards you and press on the upper edge 

of the blade block (6) with your thumb (pic. 6). 

•  Apply the lubricating oil (14) to the junctions between 

the fixed and moving parts of the blades (pic. 2). 

• 

Install the blade block (6) back to its place. To do this, 

first insert its lower part to the installation place and 

then press on the upper edge of the blade block (6). 

Make sure that the blade block (6) is installed and 

fixed properly (pic. 9). 

•  Switch the hair clipper on by pressing the button (5) 

«   » and let it operate for approximately 30 seconds 

to spread the oil across the rubbing surfaces of the 

blades. 

• 

Switch the hair clipper off by pressing the button 

(5) «   » again and remove the excessive oil with a 

paper towel or a dry cloth. 

BUTTON 

«   »

 (5)

•  To switch the hair clipper on press the button  

(5) «   », the hair clipper will switch on and the 

button lighting will light up. The charging level digital 

symbols (3) will appear.

•  Press the button (5) «   » again to switch the turbo 

mode on, the symbol (2) «   » will light up.

•  Press the button (5) «   » again to switch the hair 

clipper off.

• 

To switch the lock mode on press and hold the button 

(5) «   » for 5 seconds, the symbol (8) «   » will light