Машинки для стрижки Atlanta ATH-6925 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
7
INSTRUCTION MANUAL
2. Install the required clipping head. In order to disconnect the installed head,
toughly press the locking buttons (B) simultaneously and pull the head up. Then
install a new head in its place until the typical click of locking is heard.
3. Install one of the attachments, if required. The attachment should be installed
as follows: firstly, its front part should be matched, and then the lock in the rear part
of the attachment should be lowered and latched. If the lock of the attachment does
not fit the proper place without an effort, then its front part is installed incorrectly.
The attachment should be removed inversely as follows: firstly, the lock in its rear
part should be disengaged, and then the attachment can be completely removed.
4. In order to change the length of the hair clipping attachment, push the button in
its lower part and pull forward or back guided by the length indicated in the left lower
part of the attachment. The beard attachment moves without a lock and it can be
installed in one of the four positions indicated at the side of the head.
5. If you need a length exceeding 20 mm, remove the attachment and use the
comb, or adjust the length with the fingers of your free hand.
6. Set the switch (C) into the I position and start clipping. Change the attachments
and clipping heads only when the device is switched off.
7. Firstly, handle a small section of hair to get used to the length of the hair being cut.
Start to clip from the occipitals and at the sides, then clip in the front moving to the
crown; all the movements should be performed against the hair growth direction.
8. Watch the speed of movement of the device when clipping. The best results can
be achieved when the device moves with its internal speed without being manually
accelerated.
9. The final treatment should be performed without an attachment by light stroking
movements along the hair growth direction starting from the crown.
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
