Atlanta ATH-6875 - Инструкция по эксплуатации - Страница 6

6

INSTRUCTION MANUAL

8.  Watch the speed of movement of the device when clipping. The best results can 
be achieved when the device moves with its internal speed without being manually 
accelerated. 
9.  The final treatment should be performed without an attachment by light stroking 
movements along the hair growth direction starting from the crown.

10.  After cutting the main part of the hair should set the lever to adjust the removal 
of hair in the upper position and trim a little. In this position of blades the
hair  clipper    will  take  off  a  little.  To  trim  back  side  use  down  a  little  gentle 
movements. 
11.  Upon  completion  of  clipping,  set  the  switch  (C)  in  the  off  position.  If  the  device 
was plug-in, do not forget to disconnect it.

The  attachment  is  recommended  to  be  set  in  the  position  enabling  to  leave  the 
longer hair; if required, the position for leaving the shorter hair can be set later.
5.  Set  the  switch  (C)  into  the  forward  position  and  start  clipping.  Change  the 
attachments only when the device is switched off.
6.  If  you  need  a  length  exceeding  12  mm,  remove  the  attachment  and  use  the 
comb, or adjust the length with the fingers of your free hand.

7.  Firstly, handle a small section of hair to get used to the length of the hair being cut. 
Start to clip from the occipitals and at the sides, then clip in the front moving to the 
crown; all the movements should be performed against the hair growth direction.