Telefunken TF-CSRP3444 - Инструкция по эксплуатации - Страница 6

6

Instruction manual

6

repeatedly FOL+ or FOL- button on the RC 

to select a folder.

•  Select a desired track by using 

/

buttons on the unit or 

 or 

 buttons 

on the RC.

•  Press PROGRAM (PROG) button again to 

confirm. The set will advance to next memory 
position, the display will show “P02”. Repeat 
two steps described above to enter additional 
memories into the program if necessary.

•  After the maximum of 99 tracks (or less) 

have been selected as described above, press 

USB button on the unit or on the RC to 

start playing the programmed tracks.

•  The “PROGRAM” symbol will remain on 

to indicate that you have saved a program-
memory (sequence).

•  To check the program you stored, after 

the programming is completed, in stop mode 
press PROGRAM (PROG) button, then press 
repeatedly 

 button on the unit or 

button on the RC to see all programmed track 
numbers.

•  The program memory will be cleared when 

you press STOP button twice, open the disc 
compartment door or turn off the disc player or 
power supply.

  Good quality sound is guaranteed only 

when playing licensed MP3 discs.

USB playback

•  This unit is equipped with a USB socket 

that can accept and play MP3 files stored on 
standard USB flash (compatible with USB 
versions 2.0) up to 16 Gb.

•  To use USB drives for MP3 playback, slide 

the function switch to CD/MP3 position. Insert 
the USB drive into the USB port and press and 
hold 

USB button on the unit or on the RC 

until the display shows “USB”.

•  All operations with files contained in USB 

are the same as operations with MP3 discs.

  Always switch off the unit or change 

mode to CD before removing a USB flash 
drive, to prevent damage to your USB device.

Note:

 Although this product is fully 

compatible with USB 2.0 standard formats, 

a small percentage of USB flash drives 
might not be readable, due to those device 
manufacturers non-compliance with the full 
(official) USB standards. FAT/FAT32 file 
systems are supported.

iPod/iPhone docking

•  Open the iPod jack compartment cover 

and connect your iPod or iPhone to the jack. 
Be careful, the jack can be easily damaged. 
Ensure the connection is good for a better 
contact.

•  Set the function switch to AUX position. 

The battery of the connected device will be 
automatically charged by the power of this unit.

•  When the device is connected, this unit 

will serve as amplifier and speaker for music 
played in the connected device. Rotate VOL 
regulator on this unit to adjust volume. All 
playback operations are performed by the 
controllers of the connected device.

•  If you connect an external device through 

the AUX input and iPod at the same time, the 
iPod/iPhone docking will not function.

 Only 30pin external devices are 

supported, newer models require a special 
connector (not included).

“Dynamic Bass Boost” system

For increased bass at all volume levels, 

press BASS button for an emphasized bass 
sound. Press the button again to disable the 
function. When the function is activated, BASS 
indicator will light up in red.

Maintenance and care

•  Check your batteries regularly, old or 

discharged batteries should be replaced. If the 
unit is not going to be used for some time or is 
being run exclusively on the alternative power, 
remove the batteries to avoid leakage and