Магнитолы Soundmax SM-CMD3015 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
33
Troubleshooting guide
Below is a table describing simple measures that can help you eliminate most problems likely to emerge
when this unit is in use. If below measures do not help, turn to a service center or to the nearest dealer.
Symptom
Cause
Solution
The car ignition is not on.
If the power supply is properly connected to the
car accessory switch the ignition key to “ACC”.
No power
The fuse is blown.
Replace the fuse.
Volume is on minimum.
Adjust volume to a desired level.
No sound
Wiring is not properly connected.
Check wiring connection.
The installation angle is more than 30
degrees.
Adjust the installation angle to less than 30
degrees.
Bad sound quality
The disc is extremely dirty or defective.
Clean the compact disc/try to play a new one.
The unit already contains a disc.
Remove the disc in the player then put a new
one.
Disc cannot be
loaded or ejected
Moisture condensation.
Leave the unit idle for an hour, then retry.
The disc is inserted upside down.
Insert the compact disc with the label side
facing upward.
Compact disc is extremely dirty or
defective.
Clean the disc or try to play a new one.
Disc cannot be
read
Temperature inside the car is too high.
Cool off until the ambient temperature returns
to normal.
The built-in microcomputer is not
operating properly.
Reset the unit with the help of RESET button.
Buttons do not
work
Front panel is not properly fix into its
place.
Install the front panel properly.
The radio does
not work
The antenna cable is not connected.
Insert the antenna cable properly.
The radio station
automatic tuning
does not work
The signals are too weak.
Select stations manually.
