Hyundai Electronics H-CDM8025 - Инструкция по эксплуатации - Страница 16

 16

Sound adjustment

Turn and hold VOL knob or press VOL+/VOL- buttons to adjust following sound parameters: VOL (volume)/BASS/TRE
(treble)/BAL (left/right channel balance)/FAD (front/rear channel balance). To select a parameter, press SEL button shortly until
the desired parameter is shown on the display.

Note:

 Treble and bass adjustment is not available if DSP (equalizer) function is activated.

Other parameter setting

To choose the corresponding parameter, press and hold SEL knob for 2 seconds, and then press it repeatedly until the display
shows the parameter. Turn and hold VOL knob or press VOL+/VOL- buttons to choose the needed value. After choosing, please
leave the unit idle to activate.
TA SEEK/TA ALARM
In  TA  SEEK  mode,  the  unit  will  seek  for  traffic  announcement  program  when  TA  is  pressed;  in  TA  ALARM  the  unit  does  not
retune to TA information, but beeps will come out.
MASK DPI/MASK ALL
During  MASK  DPI  mode,  the  unit  will  mask  only  the  AF  which  has  different  PI,  this  is  the  default  mode;  during  MASK  ALL
mode, the unit will mask the AF which has different PI and no RDS signal with high field strength.
RETUNE S/L - SHORT/LONG
“RETUNE” refers to the time period the unit allows for radio scan when reception is interrupted. “S” represents a time period of
45 seconds and “L” represents a time period of 120 seconds.
DSP MODES
Choose equalizer mode: POP => ROCK => CLASS => FLAT =>DSP OFF.
LOUD ON/OFF
Select LOUD ON or OFF. In ON mode the bass and treble response will be boosted. Recommended to activate when listening at
a low volume level.
WOOF ON/OFF
Select the Subwoofer function ON or OFF.