Магнитолы Hyundai Electronics H-1419 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
6
•
Press CD key to enter CD mode.
•
Put a CD into the CD compartment and close the CD door.
•
The display will indicate "READ" for a few seconds and then start to play the first track.
•
The display will indicate the current track number and playback time.
Play/pause mode
•
Press the PLAY/PAUSE button to pause at any track when playing. Press PLAY/PAUSE button again to resume playing.
•
To stop the CD, press the STOP button. If you press PLAY/PAUSE button now the playback will start from first track.
Skip and search mode
•
Press the NEXT/TUNE UP button once to skip to the next track. Press and hold this button to search for a particular point at high speed forward. Release
the button to resume normal play.
•
Press the BACK/TUNE DOWN button once to the beginning of the current track. Press the BACK/TUNE DOWN button twice to skip back to previous
track. Press and hold this button to search for a particular point at high speed backward. Release the button resume normal play.
Repeat, intro and random modes
•
Press the MEM/PROG/P-MODE key repeatedly to select the following options:
-
REPEAT – to repeat the current track
-
REPEAT ALL – to repeat all tracks (full CD, USB or SD)
-
INTRO – to "sample" all the music on the CD/USB/SD (about first 12 seconds of every song will be played)
-
RANDOM – to play a random mix of all the songs on CD/USB/SD
Program mode
•
Up to 60 tracks can be programmed for disc play in any order or the same track can be repeated up to 60 times.
•
Before use, be sure to stop the CD by pressing the STOP button.
•
Press the MEM/PROG/P-MODE
key. The display will show "P01". This indicates that the set is now in memory programming mode, at the first memory
position.
•
Select a desired track by using the BACK/TUNE DOWN and NEXT/TUNE UP buttons.
•
Press the MEM/PROG/P-MODE
key again to confirm.
•
The set will advance to next memory position, the display will show "P02".
•
Repeat steps described above to enter additional memories into the program if necessary.
•
After a maximum of 60 songs (or less) have been selected as described above, press the PLAY/ PAUSE button to start playing the programmed tracks.
•
The "PROG" symbol will appear to indicate that you have saved a program-memory (sequence).
•
The program memory will be cleared when you press STOP button twice.
