Магнитолы Hyundai Electronics H-1410 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
2
Power supply
BATTERY OPERATION
·
Open the battery compartment cover.
·
Insert 6 batteries (UM-1). Please observe correct battery polarities or the set will not work.
·
Close the battery compartment cover.
AC OPERATION
·
Before the first connecting of the appliance check that voltage indicated on the rating label corresponds the mains voltage in your home.
·
Plug the corresponding end of cord into the AC socket on the rear of the set.
·
Insert the plug into power supply.
CAUTION:
·
When the set is only used with AC or is not used for 2 weeks or more, please remove the batteries, to avoid damage to the set from leakage of batteries.
·
Always switch off the unit when not in use.
·
Always unplug the appliance from power supply, when no use long time.
Stereo headphone connecting
·
For private listening, insert 3.5 mm headphone into the stereo headphone jack.
·
Adjust volume control to the appropriate level as desired.
·
When the stereo headphone jack is plugged, speaker will disconnect automatically.
Radio operation
·
Set Function switch to RADIO position.
·
Select your desired broadcasting band with Band switch.
·
Press NEXT/TUNE-UP button or NEXT/TUNE-UP button and then release the button when the fast scanning starts. The frequency will continue to
change and will automatically stop when a broadcast station is received.
·
To receive a weak broadcast signal press the NEXT/TUNE-UP or NEXT/TUNE-UP button by one press at a time and adjust the frequency you wish to
receive.
RADIO STATION MEMORY
·
12 broadcast stations of FM band, 6 AM and 6 LW stations can be stored to the preset memory.
·
During tuner mode, find a desired station.
·
Press MEM button to make the channel display appear.
