Wallner OL290 - Инструкция по эксплуатации - Страница 5

© ARGO S.A.

www.argo.pl

5

EN

Operating instructiOns

saFetY instructiOn marks

 WARninG

HOt! may cause physical injury or harm. Keep off touching or direct collision on body.

1.  ON/OFF switch:

 it is to switch on or off the power supply

2.  HOT/COLD switch:

 it is to choose cold or hot lamination

3.  RED LED:

 Reffering that the power is well connected; if the the HOt/COLD switch is 

in HOt position, it means laminator is in pre-heating process; if in COLD position, it 

means the laminator is ready to laminate

4.  GREEN LED:

 Ready for Hot lamination 

5.  RELEASE/REVERSE:

 Jam release button

 eLectricaL appLicatiOn

Apply for use only on proper electric power usage as indicated in rating plate on laminator. 

Keep on easy plugging and unplugging situation.

OperatiOn prOcedures

1.  it is normal that new laminator could smell irritated in beginning, please keep fluent 

air ventilation before using.

2.  Place laminator on table leaving enough space for the laminated object to access and 

come out from the laminator smoothly.

hOt LaminatiOn

1.  HOt Lamination: turn the switch to „HOt” and wait until the GREEn light READY 

illuminates, which means warm up is completed and laminator is ready to use. to 

stabilize the thermal conditions and increase lamination quality, please wait a few 

minutes after the READY diode will light up before you start laminating the docu-

ment. normal papers or laminating pouches from 80 microns  to 125 microns, can be 

proceeded on this stage.

2.  We suggest to turn the switch to OFF for 30 minutes and cool the laminator after HOt 

lamination for 30 minutes, then start the new HOt lamination.

3.  Press the switch to „OFF” and when not in use for safety precaution.

cOLd LaminatiOn

1.  Cold lamination is at its best performance for cabinet temperature less than 35°C(95°F); 

this machine will not generate heat on the cold lamination stage, please keep machine 

temp under 35°C(95°F).

2.  Use the cold lamination pouches only.

3.  Cold lamination is for fax paper, light sensitive photos and other papers / documents 

that will be affected by heat.

4.  turn the switch to „COLD” position then insert the papers into cold lamination pouch