GBC 1100 - Инструкция по эксплуатации - Страница 6

GB

6     

register this product online at www.accoeurope.com

getting ready to laminate

Easy Set Up

1

   Take the electrical plug and place in an appropriate power source, which is near the table you 

intend to use.

2

   The laminator will respond with a single beep and a sequence of brief flashes across the control 

panel.

3

   To use the laminator move the slider to the right from the ‘ ’ to the 75 mic or 125 mic position 

depending on which pouch selected. Below the slider you will see a white line, this indicates that 

you have switched the laminator on.

loading the pouch

1

   Take your item to be laminated and place in to the appropriate sized laminating pouch,  

ensuring it is firmly located along the sealed edge. This is to help ensure that you get optimal 

quality output.

Before laminating important or unique documents, always run a test pouch through  

the laminator using a similar type document.

SEALED EDGE

A3, A4, A5, etc.

Irregular shaped item

SEALED EDGE

NOTE:  Do not cut pouches prior to 

lamination.

a

b

NOTE:  Your new laminator may emit a slight 

odour during the initial operation. Its 

is normal and will diminish after a few 

hours of operation.

NOTE:  only use 75micron/80 micron, 100 

micron or 125 micron pouches with 

this laminator.

Visual & Audible Ready Alerts

4

   The laminator will start to warm up - an orange light will be illuminated to the right of the 

‘

’

 (a). 

When the laminator is ready to use the green light next to the 

‘tick 

’

 is illuminated (b) and a 

series of two beeps are heard.