Fellowes Pixel (FS-56016) - Инструкция по эксплуатации - Страница 5

5

Let our experts help you with a solution.

Customer Service...   

www.fellowes.com

Always call Fellowes before contacting your place of purchase, see the rear cover for contact details.

NEED HELP?

Ensure the machine is on a stable surface.  

Check there is enough clear space (min 50cm) behind the machine to allow 
items to pass through freely.

Plug the machine into an easily accessible main socket.

1.

2.

3.

SETTING UP THE LAMINATOR

Switch off the machine at the wall. Allow the machine to cool. The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to 

polish the machine.

Problem

Possible cause

Solution

No control panel illumination

Machine not switched on

Switch on machine at rear next to plug inlet and at the wall socket

Laminator has gone in to Auto Shut Off 

mode

Press any button or cycle the power switch to re-start the machine

Pouch does not completely seal the item

Item may be too thick to laminate

Check pass through thickness is correctly selected and pass through again

Temperature setting may be incorrect

Check pouch thickness is correctly selected and pass through again

Pouch has waves or bubbles

Temperature setting may be incorrect

Check pouch thickness is correctly selected and pass through again

Pouch is lost in the machine

Pouch is jammed

Operate the release lever and pull out the item by hand

Jamming

Pouch was used ‘open end’ first

Pouch was not centred on entry

Pouch was not straight upon entry

Empty pouch was used

TROUBLESHOOTING

STORAGE & CLEANING

HOW TO LAMINATE

Switch the power on (located at the rear of the machine).

The machine defaults to the cold setting. For 80 microns or 125 microns hot 
laminating, press the 

 once for 80 microns or twice for 125 microns. 

When the machine is ready, temperature setting button will stop flashing and 
remain on.

Place the document into the open pouch. Ensure the document is centered against 
the sealed edge. Use the appropriate pouch size for the document.

Ensure the pouch enters the machine sealed edge first. Keep the pouch straight 
and central within the slot, not on an angle.

Upon exit, the laminated pouch may be hot and soft. For the best quality and to 
prevent jamming remove the pouch immediately. Place the pouch on to a flat 
surface to cool. Take care when handling a hot pouch. Always remove laminate 
pouch before starting next laminate.

To release a pouch during lamination, activate the release lever located at the 
rear of the machine. Gently pull pouch out of machine.

4.

5.

6.

7.

8.

9.

10.