Autel EVO II Dualgged Bundle (640T) V3 (102001752) - Инструкция по эксплуатации - Страница 38

37

FCC and ISED Canada Compliance

This device complies with part 15 of the FCC Rules and ISED Canada 

licence-exempt RSS standards. Operation is subject to the following two 

conditions:
(1) This device may not cause harmful interference, and 

( 2 )   t h i s   d e v i c e   m u s t   a c c e p t   a n y   i n t e r f e r e n c e   r e c e i v e d ,   i n c l u d i n g 

interference that may cause undesired operation.

Le présent appareil est conforme aux CNR dʼISED Canada applicables aux 

appareils  radio  exempts  de  licence.  Lʼexploitation  est  autorisée  aux  deux 

conditions suivantes : 

(1) lʼappareil ne doit pas produire de brouillage, et 

(2) lʼappareil doit accepter tout brouillage radioélectrique subi, même si le 

brouillage est susceptible dʼen compromettre le fonctionnement.

NOTE:

This equipment has been tested and found to comply 

with the limits for a Class B digital device, pursuant to part 

15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses 

and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more 

of the following measures:

• 

Reorient or relocate the receiving antenna.

• 

Increase the separation between the equipment and receiver. 

• 

Connect the equipment into an outlet on a circuit different

   from that to which the receiver is connected. 

• 

Consult the dealer or an experienced radio/TV technician

   for help.
Changes or modifications not expressly approved by the 

party responsible for compliance could void the user's 

authority to operate the equipment.