Philips HR7771 - Инструкция по эксплуатации - Страница 12

12

 4 

 Let the appliance run for at least 30 seconds until the food 

processor bowl or blender jar is clean. 

 5 

 Detach the blender jar or food processor bowl and rinse it with 

clean water. 
Balloon beater (HR7772)

Always clean the balloon beater immediately after use. 

The balloon beater can be cleaned in the dishwasher. You can also pull the 

beaters out of the balloon beater to clean them separately. 

 1 

 Pull the beaters out of the balloon beater housing.  (Fig. 40)

 2 

 To reassemble, push the beaters back into the balloon beater 

housing. 
Citrus press

Always clean the citrus press immediately after use.

The citrus press can be cleaned in the dishwasher. You can also pull the 

cone from the sieve to clean them separately. 

 1 

 Pull the cone from the sieve (Fig. 41).

 2 

 To reassemble, push the cone back on the sieve of the citrus press. 

storage

 1 

 Push the cord into the cord storage compartment on the back of 

the motor unit.  (Fig. 42)

Environment

 - Do not throw away the appliance with the normal household waste 

at the end of its life, but hand it in at an official collection point for 

recycling. By doing this, you help to preser ve the 

environment (Fig. 43).

EnglisH

12

guarantee & service

If you need ser vice or information or if you have a problem, please visit 

the Philips website at www.philips.com or contact the Philips Consumer 

Care Centre in your countr y (you find its phone number in the 

worldwide guarantee leaflet). If there is no Consumer Care Centre in 

your countr y, go to your local Philips dealer.

troubleshooting

This chapter summarises the most common problems you could 

encounter with the appliance. If you are unable to solve the problem with 

the information below, contact the Consumer Care Centre in your 

countr y. 

Problem

Solution

When I select a 

speed or press the 

pulse/Easy Clean 

button, appliance 

does not star t to 

operate. 

Make sure the food processor or blender jar and 

its lid are assembled correctly (‘click’).Make sure 

that the tool holder has been inser ted properly if 

you are using any accessor y with the food 

processor bowl. If you use the blender jar, make 

sure that the handle of the blender points to one 

of the four corners of the motor unit. Keep the 

lid fixed to avoid spillage. If you use the food 

processor, make sure that the bowl handle is 

directly above the closed lock symbol. The bowl 

lid is correctly assembled when the projection is 

locked into the slot of the bowl handle. If all par ts 

are assembled correctly, the appliance star ts to 

operate when you select a speed with the speed 

selector or press the pulse/Easy Clean button.

The 

appliance suddenly 

stops running.

The thermal safety cut-out has probably cut off 

the power supply to the appliance because the 

appliance has overheated. 1) Unplug the 

appliance. 2) Let the appliance cool down for 1 

hour. 3) Put the mains plug in the socket. 4) 

Switch on the appliance again.