Philips HR7758 - Инструкция по эксплуатации - Страница 20

E N G L I S H

2 0

Solution

The appliance will fail to respond to the + button when
the motor has already reached its maximum load, e.g.
because you are processing large quantities of dough.
This is normal and does not mean that the appliance is
defective. Check the quantities mentioned in the tables
in the instructions for use to prevent overloading the
appliance. The appliance will not respond to the - button
when the motor is already running at the lowest speed.

Check whether the cutting edges of the cutter unit are
pointing outwards.

Make sure the gear housing and the cutter housing have
been assembled correctly. You will hear a click when they
have been fastened properly.

Unscrew the screw ring a little and then place the cutter
unit and the grinding disc properly onto the worm shaft.
Then screw the screw ring properly onto the cutter
housing.

You used the medium grinding disc. Use the fine one.
Mince the meat again to get a finer result.

The par ts have been cleaned in the dishwasher. You
should clean all par ts by hand and dr y them
immediately with a tea towel.

Problem

The + button or -
button does not work
during cer tain jobs.

The meat looks as if it
has been 'pressed
through' rather than
minced.

The meat mincer does
not work.

The cutter unit cannot
be placed properly in
the cutter housing.

The result is too
coarse.

The metal par ts of the
meat mincer look
rusty.

Answer

No!

No!

No!

No!

No, you should only use the pusher.

Question

Can I also mince bones or
bacon rind with the meat
mincer?

Is it possible to mince frozen
meat with the meat mincer?

Is it possible to clean the cutter
unit and grinding discs in the
dishwasher?

Do I need the cutter unit to
make sausages?

Can I use a wooden spoon or
a similar object to push down
the meat?