Bosch MultiTalent 3 MCM3PM386 - Инструкция по эксплуатации - Страница 23

 23

en

 Operation

Smart tool detection (MCM3P...)

Every speed setting is identified with a differ-

ent colour (grey and red). This colour coding 

system can also be found on the acces-

sories. The accessories are automatically 

connected to the right speed setting.

Low speed, grey 

with drive shaft

For using tools and cutting discs.

High speed, red 

without drive shaft

For using the blender and universal 

cutter.

Preparation

■

Place the base unit on a smooth, clean 

surface.

■

Pull cable out of the base unit to the 

required length.

Important information

– Use only the rotary switch to switch the 

appliance on or off.

– Never switch the appliance off by rotating 

the bowl, the blender or a tool.

– Do not switch the appliance on unless 

tools or accessories have been completely 

attached.

Bowl with accessories/tools

W

Risk of injury from the rotating tools!

While the appliance is operating, never place 

fingers in the mixing bowl. Always use the 

pusher for adding ingredients. After switching 

off, the drive continues running for a short 

time. Change tools only when the drive is at 

a standstill.

Warning!

When working with the bowl, the appliance 

cannot be switched on until the bowl has 

been attached and the lid has been attached 

and screwed on tight.

Universal blade

for cutting, mincing, mixing.

W

Risk of injury from sharp blades!

Do not touch blades of the universal blade 

with bare hands. When not in use, always 

store the universal blade in the blade guard. 

Grip the universal blade by the edge of the 

plastic handle only.

Kneading hook

for kneading dough and mixing-in 

ingredients that ought not be cut (e.g. raisins 

and chocolate chips).

Beating disc

for cream, egg white and 

mayonnaise.

Fig. 

B

■

Attach the bowl (arrow on bowl on dot on 

the appliance 

.

) and rotate as far as 

possible in a clockwise direction (

,

).

■

Insert tool holder into the bowl.

■

Insert universal blade, whisking disc or 

kneading hook into the tool holder and 

release. 

Note position of the tools when 

inserting them! Press tools all the way 

down.

Warning!

Do not add ingredients until the tools have 

been inserted.

■

Add ingredients.

■

Attach lid with pusher (match arrow on 

lid on dot on bowl 

.

) and rotate in 

a clockwise direction (

,

). Lid lug must be 

located fully in the slot in the bowl handle.

■

Insert the mains plug.

■

Set the rotary switch to the desired setting.

■

To add more ingredients, set the rotary 

switch to 

P

.

■

Remove the pusher and add ingredients 

through the feed tube. Pusher can be used 

as a measuring cup.

Cutting discs

W

Risk of injury from sharp blades!

Do not grip the sharp blades or edges of the 

cutting discs. Grip the discs by the plastic 

part in the centre only! Do not place fingers 

in the feed tube. Only use the pusher when 

adding more ingredients.

Slicing reversible disc –  

thick/thin 

for slicing fruit and vegetables. 

Process at setting 1.
Identification on the reversible slicing disc: 

“grob” for the thick cutting side,  

“fein” for the thin cutting side