Краскораспылители Fubag AGS7/0.2 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
www.fubag.ru
O
m
perator's
anual
- 5 -
For cleaning proceed as follows:
- Remove paint residuals from aerograph. Release the collet clamp and carefully take out the
needle. Carefully wipe the needle towards the needle point, turning it when wiping.
- Put some water or cleaning agent into the reservoir of the aerograph.
- Use wad of cotton wool to wipe out the paint reservoir of the aerograph.
- Use the cleaning agent to purge aerograph.
- Remove the protective cap and clean it inside with a wad of cotton wool, wet with water or the
cleaning solution.
- Tighten the cap.
- Carefully, apply light pressing force to insert the needle and fix it with the collet clamp.
- Finally clean the aerograph with the cleaning solution.
6. Troubleshooting
Fault
Cause
Remedy
The nozzle not tightened
Tighten the nozzle
The nozzle is dirty
Clean the nozzle
Air bubbles or foam appear in
the paint reservoir
The nozzle has damaged
Replace the nozzle
The paint is over in the tank
Fill the reservoir with paint
The needle not tightened
Tighten the needle
Dirty needle
Remove the cap; unscrew the nut
of the needle collet clamp, push the
trigger down and repeatedly move
the needle forward/ backwards.
Then firmly insert the needle and
tighten the clamping nut.
The nozzle is dirty
Clean the nozzle
No paint spraying
Paint is too heavy
Add the solvent into the paint
Air supply valve is dirty
Clean the valve
Air supply control is not
possible
Not enough oil on the trigger
stem
Unscrew air valve and apply the
engine oil on the seals of the air
valve stem
The needle is dirty
Clean the needle
The nozzle is dirty
Clean the nozzle
Low spraying quality
The needle or nozzle damaged.
Low quality of the used air,
pressure of the supplied air has
been set in the wrong way
Change the needle or the nozzle.
Check moisture- / oil separation
filters, adjust pressure of the inlet
air
Pressing force on the trigger is
too high
Reduce pressing force on the
trigger
Appliance is too close to the
painted surface
Take away the appliance from the
painted surface
A lot of small paint runs form
during spraying
Paint is too thin
Add less paint thinner into the paint
or reduce air pressure
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
