Mitsubishi Electric MSZ-FH25VE2 - Инструкция по эксплуатации - Страница 6

En-5

● OPERATING INSTRUCTIONS ●

ABSENCE DETECTION

This  function  automatically  changes  the  operation  to  energy-saving  operation 

when nobody is in the room. 

I

-SEE OPERATION

1

To activate this function, press 

 until 

 appears 

on the operation display of the remote controller.

2

Press 

 again to release ABSENCE DETECTION.

INDIRECT/DIRECT mode

The  INDIRECT/DIRECT  mode  offers  fi nely-tuned  operation  by  locating  where 

an occupant is in the room. 

1

Press 

 during COOL, DRY, HEAT or AUTO 

mode to activate the INDIRECT/DIRECT mode. This 

mode is only available when the i-see control mode is 

effective.

2

Each press of 

 changes INDIRECT/DIRECT in 

the following order:

 (INDIRECT) : An occupant will be less exposed to 

direct airfl ow.

 (DIRECT)  : Mainly the vicinity of an occupant will 

be air-conditioned.

•  Horizontal and vertical airflow directions will be automatically selected.

•  When  more  than  a  couple  of  people  are  in  a  room,  the  INDIRECT/

DIRECT mode may work less effectively.

•  If you still feel uncomfortable with the air direction determined by the 

INDIRECT mode, adjust the air direction manually. 

 Page 7 

3

Canceling the i-see control mode automatically cancels 

the INDIRECT/DIRECT mode.

•  The  INDIRECT/DIRECT  mode  is  also  cancelled  when  the  VANE  or 

WIDE VANE buttons is pressed.

Note:

•  Do not touch the i-see sensor. This may cause malfunction of the i-see sen-

sor.

•  The intermittent operating sound is a normal sound produced when the i-see 

sensor is moving from side to side.

Press 

 during COOL, DRY, HEAT and AUTO mode 

to activate the i-see control mode.

•  Press gently using a thin instrument.

• 

 lights. (Operation display section)

•  The default setting is “active”.

Press 

 again to activate ABSENCE DETECTION.

• 

 lights. (Operation display section)

Press 

 again to release the i-see control mode.

Note:

Any person at the following places cannot be detected:

•  Along the wall on which the air conditioner is installed

•  Directly under the air conditioner

•  Where  any  obstacle,  such  as  furniture,  is  between  the  person  and  the  air 

conditioner

A person may not be detected in the following situations:

•  Room temperature is high.

•  A person wears heavy clothes and his/her skin is not exposed.

•  A heating element of which temperature changes significantly is present.

•  Some heat sources, such as a small child or pet, may not be sensed.

•  A heat source and the air conditioner are more than 6 m apart.

•  A heat source does not move for a long time.

1

2

3

i-see control mode

In  the  i-see  control  mode,  the  room  temperature  is  controlled  based  on  the 

sensible temperature. 

(INDIRECT)  (DIRECT) 

(OFF)

JG79Y064H03_en.indd   5

5/19/2016   4:56:14 PM