Hyundai Electronics H-AR1-07H-UI010 - Инструкция по эксплуатации - Страница 12

12.

Electric  air conditioner (split system)

EN

TIMER mode

Procedure of timing:

– If the conditioner is of, then press the 

«TIMER

»

 button to activate the automatic turning on. 

Pressing this button once again, set the time for turning the conditioner on in the set time 
interval. To cancel the timer mode, press the «TIMER

»

 button once again.

–If the conditioner is working, then press the «TIMER

»

 button to activate the automatic turning 

of. Pressing this button once again, set the time for turning the conditioner of in the set time 

interval. To cancel the timer mode, press the «TIMER

»

 button once again.

«SLEEP» mode

Button «SLEEP» (Night Care). Press this button to increase (in the cooling mode) or decrease (in 
the heating mode) the air conditioner temperature in relation to the set value by 1°C per hour 
for 2 hours ater the pressing. The air conditioner will be switched of ater 5 hours of operation 

in this mode.
This mode allows energy saving and creates comfortable conditions at night.

Regulation of treated air low direction

Regulating the position of delectors (blinds), set the direction of treated air low ensuring 

uniform distribution of temperature and the most comfort conditions in the room. To change the 

position of delectors, use the 

«SWING

»

 button.

8. MAINTENANCE

• 

Before cleaning unplug the conditioner.

• 

Cleaning of the indoor unit and remote control board:

•  Indoor unit and remote control board should be cleaned with a dry sot cloth.
• 

If the indoor unit is too unclean, moisten the cloth with cold water.

• 

It  is prohibited to clean the remote control board with moist cloth.

• 

In order to avoid the damage of paint or details of the conditioner, do not clean it with brushes 
and do not leave them on the surface of indoor unit.

• 

In order to avoid the damage of surface or deformation of the conditioner details, do not clean 
it with petrol, solvents, cleaning powders or other chemically active substances.

• 

Before a sustained interruption in the conditioner work:

• 

Turn the conditioner on for several hours in the FAN mode. It will allow you to dry its inner 
cavities

• 

Unplug the conditioner. Remove the batteries from the remote control board. Checks before 
starting:

•  Make sure that an air ilter is installed.
• 

Make sure that air inlet and outlet grilles of the outdoor unit are not blocked by foreign objects.

•  Cleaning of air ilter
•  Air ilter cleans the air entering the conditioner from dust and foreign particles. If the ilter is 

contaminated, the conditioner capacity decreases sharply.

•  If the conditioner is operated permanently, the ilter should be cleaned once per two weeks.
•  If the conditioner is installed in a room with dusty atmosphere, then the air ilter should be 

cleaned more oten.

•  To remove the ilter, open the indoor unit panel.
•  Remove air ilters. Clean the ilter with a vacuum cleaner or rinse it in clean water. If the ilter is 

contaminated heavily, clean it with a sot brush and wash in diluted washing solution, then dry 

it in a cool place.

•  While cleaning the ilter with the vacuum cleaner, hold it with contaminated surface up. While 

washing the ilter in water, hold it with contaminated surface down.

•  Do not dry the ilter in the sun or near a ire.
•  Set the air ilter to initial position and close the panel.