Russell Hobbs 25270-56 - Инструкция по эксплуатации - Страница 4

4

BEFORE USING FOR THE FIRST TIME

Fill the reservoir to the 

max

 mark, and run the appliance without coffee.

FILLING

1. 

Remove the carafe from the hotplate.

2.  Open the lid.

3.  Fill the reservoir with the exact amount of water required. Note that the brewing process will use all 

of the water that you put in the reservoir.

4. 

Make sure that the filter holder is pressed down all the way into position. It will click when correctly 

installed. 

5.  Put a #4 paper filter into the filter holder.

6.  The reservoir is calibrated to give 12 large cups (at 125ml per cup) and 18 small cups (at 83ml per cup). 

For each large cup, add 6g of ground filter coffee and for each small cup add 4g.

7. 

Close the lid.

8.  Replace the carafe on the hotplate.

SET THE CLOCK

It isn’t neccessary to set the clock to use your coffee maker but you will need to set it if you want to use 

the timer functions.

1. 

Put the plug into the power socket.

2.  Use the 

hr

 and 

min

 buttons to set the correct time in 24 hour format.

• 

The clock will retain its settings until the coffee maker is unplugged.

COFFEE STRENGTH 

Pressing the 

f

 button will make the brewed coffee slightly stronger. You can also use it if you are only 

brewing a partial carafe of coffee (i.e. not completely filling the reservoir). Your coffee maker will then alter 

the brewing process so your coffee will have about the same strength as it would if you had made a full 

carafe.  

MAKING COFFEE

Note: If you want to use the coffee strength feature press the 

f

 button before pressing the 

W 

button. 

The 

f

 button will light up.

1. 

Press the 

W

 button – the 

1

 icon will appear on the display. The 

W

 button will light up.

2.  Shortly afterwards, coffee will start to drip into the carafe.

3.  If you want to stop the coffee maker while it’s brewing, press the 

W

 button.

4. 

Once brewed, the hotplate will keep the carafe warm for up to 40 minutes.

STATUS LIGHT

The status light will operate as follows:

Brewing

Flashes slowly

Keep warm

Stays lit

Last 10 minutes of keep warm

Flashes quickly

USING THE TIMER

Note: Make sure the clock is set to the correct time. Use the 

hr

 and 

min

 buttons.

1. 

Set the timer to the time you want to start brewing.

a)  Press the 

T

 button.

b)  Use the 

hr

  and 

min

 buttons to set the time you want brewing to start.