Krupsl EA816570 - Инструкция по эксплуатации - Страница 31

29

If one of the problems described in the table persists, contact KRUPS customer service.

PROBLEM MALFUNCTION

CORRECTIVE ACTION

Your machine detects a fault: 
a   symbol appears.

Switch off and disconnect the machine, remove the filter cartridge, wait for a 
minute and restart the machine.

The appliance does not turn 
on when the   button is 
pressed.

Check your fuses and plug sockets.
Check that the two power plugs are pushed in properly both on the appliance 
and at the socket.

The coffee grinder makes a 
strange noise.

There is a foreign body in the grinder. Disconnect the machine before inves-
tigating.
See if you can extract the foreign body using your vacuum cleaner.

The steam nozzle makes a 
noise.

Check that the steam nozzle is correctly attached to its corresponding end 
piece.

The steam nozzle on your  
machine seems partially or  
completely clogged.

Ensure that the opening in the end piece is not obstructed by milk residue or  
limescale. Unclog the holes with the needle supplied with your appliance.

The steam nozzle makes little 
or no milk froth.

For milk-based drinks, you use very fresh, very cold pasteurised or UHT milk. 
It is also advisable to use a cold container.  If the results do not improve, try 
changing the brand of milk.

No steam comes out of the 
nozzle.

Empty the tank and temporarily remove the filter cartridge. Fill the water tank 
with mineral water which is high in calcium (> 100 mg/l) and run successive 
steam cycles.

The auto-cappuccino setting 
makes little or no froth.
The auto-cappuccino setting 
does not take in milk.

Check that the accessory is correctly attached to the appliance, remove it 
then replace it.
Check that the flexible tube is not obstructed or pierced and that it is correctly  
attached to the accessory so as to make it airtight. Rinse and clean the ac-
cessory (refer to the “Auto-cappuccino accessory” chapter).

There is water underneath the 
appliance.

Before removing the water tank, wait for 15 seconds after the coffee has fini-
shed flowing so that the machine finishes its cycle properly.
Check that the drip tray is correctly positioned on the machine; it should 
always be in place, even when the appliance is not in use.
Check that the drip tray is not full.
The drip tray should not be removed during a cycle.

After emptying the coffee 
grounds collector, the warning 
message is still displayed on 
the screen.

Correctly replace the coffee grounds collector and follow the instructions on 
the screen. 
Wait at least 8 seconds before replacing them.

TROUBLESHOOTING