Black+Decker BXCO1200E - Инструкция по эксплуатации - Страница 6

ENGLISH

(Original instructions)

6

Š

When first starting:

Š

When the tank has run out of water.

Š

Fill the receptacle taking care to observe the MAX level 

Š

Connect the appliance to the mains.

Š

Press the on/off switch (F) to ON position. The (E) pilot 

light will come on in red colour

Š

You do not have to wait for the machine to heat up for 

this operation

Š

Without fitting the filter holder (H) (or with the filter holder 

fitted, but without coffee), place a recipient under the 

position of the coffee cup

Š

Select the coffee position by rotating the D control to this 

position

Š

Water will exit through the filterholder position. Wait until 

approximately one cupful has exited

Š

To finish serving, rotate the selection control D to the 

central position 0 

Š

This will complete the priming operation.

Filling with water:

Š

The tank must be filled with water before turning the 

appliance on.

Š

Remove the water tank.

Š

Open the cover.

Š

Fill the tank taking care to observe the MAX level 

Š

Close the lid.

Š

Replace the tank in its housing, ensuring that it is well 

fitted.

Filling Coffee:

Š

Remove the filter holder (H)

Š

Position the selected ground coffee filter (J or K) in the 

filter holder 

Attention

Filter extraction   

Š

The filterholder includes a spring inside, whose function 

is to avoid the fall of the sieve when throwing the used 

coffee. That spring produces a lateral tightening on the 

filter

Š

Due to this tightening, to remove the filter for exchange 

or cleaning, it may be necessary to use a tool.

Š

We recommend using a roundtipped knife or a tip of a 

teaspoon, so that it can be placed between the upper 

edge of the filterholder and the bottom of the sieve wing

Š

A small turn will cause them to separate from each other 

and will facilitate the extraction

Š

Filter J (smaller one) can be used either for ground 

coffee or paper pods

Š

We recommend using natural toast coffee, as using 

some roasted coffee may affect the operation of the 

machine.

Š

Fill the chosen removable filter (1 or 2 cups) with ground 

coffee (6-7 g per cup to be prepared).

Š

Using measuring spoon (I) for 1 coffee, put 1 spoonful 

and for 2 coffees, put in 2 spoonfuls.

Š

Next lightly press down the ground coffee with the back 

of the spoon.

Š

Before fitting the filter holder in the coffeemaker assem-

bly, turn the ladleholder backwards.

Š

Fit the filter holder in the appliance once more. 

Š

 Position the filter holder in the coffee assembly by inser-

ting the assembly downwards and turning it anticlockwi-

se, from left to right, until it locks.

USE

Š

Connect the appliance to the mains.

Š

Turn the appliance ON using the on/off switch (F)

Š

The (E) pilot light comes on red intermittently

Š

Wait until the pilot light E change it’s lighting to blue. It 

means right temperature is reached

Š

Place one or two preheated cups at the filter holder 

outlet.

Š

Turn the Control Knob (D) to the coffee position 

Š

The coffee infusion will begin to exit. When you have ob-

tained the desired quantity of espresso coffee (short or 

long), turn back control knob (D) to the central position 0 

Š

Once serving has finished, wait a few seconds and 

remove the cups with the coffee.

Š

Remove the filter holder and empty the grounds from it.

Š

Wash the filter holder with running water and dry it well.

Š

Check that the removable filter is perfectly fitted into the 

filter holder.

Š

Fit the filter holder in the appliance once more. 

Š

NOTE: After the espresso is brewed, the machine 

automatically creates a bit of steam and pushes the 

remaining water from the pump into the drip tray. This 

ensures that there will be no restwater in the heating 

system. After preparing a few cups of espresso, carefully 

pull the drip tray out of the machine, empty and replace.

Preparation of coffee with paper single 

dose (PODS):

Š

If you want to use Single paper doses (POD)

Š

Remove the ground coffee filter from the filter holder (K)

Š

Introduce in the filter holder, the singledose filter (J)

Š

Then put the POD in the filter holder; Make sure that the