Clatronic KA 3733 Coffee To Go Thermo - Инструкция по эксплуатации - Страница 32

KA3733_IM

05.03.19

32

Unpacking the Appliance

1.  Remove the appliance from its packaging.

2. 

Remove all packaging material such as plastic films, filler 

material, cable ties and cardboard packaging.

3.  Sensitive surfaces are possibly protected with foil. 

Remove these foils. 

4.  Check the content for any missing parts.

5.  In the event that the packaging content should be incom-

plete or if damages are noticeable, do not operate the 

appliance. Return it to the dealer immediately.

NOTE:

There may be dust and production residue on the 

appliance. We recommend cleaning the appliance as 

described under “Cleaning”.

Overview of the Components / 

Scope of Delivery

1  Filter holder

2  Permanent filter

3  Tab for opening the water tank lid

4  Water tank lid

5  Water spout

6  Water tank

7  Water level display

-  14 OZ  420 ml

-  10 OZ  300 ml

-  8 OZ  240 ml

8  Basic appliance

9   button

10  Storage surface

11  Thermo stainless steel cup

Notes for Use

Placement

•  Place the automatic coffee maker on a stable and level 

surface. Place the appliance in such way that it cannot 

tip over. 

•  Do not place the appliance in close proximity to a gas or 

electric stove or any other heat source.

Note About the Brewing Process

During the brewing process and depending on the degree of 

grinding and the used amount, the coffee powder absorbs 

a certain amount of water. That is why the quantity of coffee 

might diverge from the quantity of water in the water tank.

European Regulations on Energy Saving

NOTE:

The European Directive 2009 / 125 / EC (Ecodesign Direc-

tive) incorporates measurements for energy saving.

The following applies to coffee makers: For coffee 

machines that store the coffee in an isolated container 

a maximum waiting time of 5 minutes applies at the end 

of the last brewing cycle. The appliance switches off 

automatically.

You benefit from better safety and lower energy con-

sumption.

Electric Connection

1.  Ensure that your mains power corresponds with the 

specifications of the appliance. The specifications are 

printed on the type label.

2.  Connect the mains cable to a properly installed and 

earthed wall outlet.

Initial Operation

Operate the appliance 2 times with clean water before 

brewing coffee for the first time. This removes dust, which 

may have collected during transport. Follow the instructions 

given under “Operation”.

Turning the Appliance On / Off

•  Press the button to switch on the appliance. The indica-

tor lamp of the button lights up.

•  Press the button again to turn off the appliance or to can-

cel brewing. The indicator lamp of the button turns off.

Operation

1.  Open the lid of the water tank.

2.  Fill the water tank with cold water.

CAUTION:

Do not overfill the tank! Do not fill it above the 

14 OZ 

420 ml

 mark.

3. 

Insert both the filter holder and the permanent filter.

4. 

Fill coffee powder into the permanent filter.

NOTE:

Do not put too much coffee powder into the filter to 

avoid spillage.

5.  Now close the lid of the water tank. It must engage.

6. 

Place the thermo stainless steel cup without lid on the 

storage surface.

NOTE:

Hold the thermo stainless steel cup slightly tilted.

7.  Switch on the appliance. The indicator lamp of the button 

lights up.