Clatronic KA 3562 - Инструкция по эксплуатации - Страница 29

29

Instructions

Placement
•  Place the automatic coffee maker on a stable and level 

surface. Place the appliance in such way that it cannot tip 

over. 

•  Do not place the appliance in close proximity to a gas or 

electric stove or any other heat source.

Electric Connection

 NOTE: 

Make sure the device is switched off. The switch must be 

at the “0” position.

1.  Ensure that your mains power corresponds with the specifi-

cations of the appliance. The specifications are printed on 

the type label.

2.  Connect the mains cable to a properly installed and earthed 

wall outlet.

Operation
Before making coffee for the first time operate the appliance 

twice with clean water only and without paper filter. This re-

moves dust, which may have collected during transport. Follow 

the instructions given under “Operation”.

Operation

1.  Open the lid of the water tank.

2.  Fill cold water according to the desired amount of cups of 

coffee into the rear water tank. The water level is displayed 

on the indicator.

 NOTE:

You can use the pot to fill the water tank. 

 CAUTION: 

Do not overfill the tank! Do not fill it above the 

MAX

 mark.

3.  Ensure that the filter holder is properly attached.

4.  Turn over the lower fold of the paper filter (size 1x4) and 

place it in the filter funnel. Then fill it with coffee powder.

5.  Now close the lid of the water tank.

6.  Place the jug onto the warming plate.

 CAUTIION: Drip stop

Your appliance comes with a drip stop. It closes when 

removing the coffee pot. This prevents the coffee from 

dripping onto the warming plate if there is still water in the 

filter.

•  Ensure that the lid is attached to the coffee pot. It 

opens the drip stop.

•  If there is still water in the tank, place the pot under-

neath as soon as possible. Otherwise the filter might 

overflow.

7.  Switch on the device. The indicator lamp in the switch will 

light up.

The Coffee Is Ready

 NOTE: 

The brewing process lasts approximately. 

8

-1

2

 minutes.

•  When no more coffee is flowing through the filter you can 

remove the pot. 

•  Turn the device off.

•  Would you like to keep the remaining coffee warm? Leave 

the machine switched on until the pot is empty.

 NOTE: 

The filter holder can be removed from the machine by its 

handle. This makes it easier to dispose of the old coffee filter, 

for example.

 WARNING:

If you want to make another pot of coffee immediately, switch 

off the device first. Let it cool down with the water tank open 

in order to avoid hot water splashing when refilling with water.

De-scaling

De-scaling is necessary when the brewing time increases 

substantially.
•  Use only commercially available citrus acidbased de-scaler. 

•  Follow the recommended instructions for use.  

 WARNING:

•  Afterwards you should boil fresh water in the pot three or 

four times in order to rinse out residues of the descaling 

agent.

•  Do not use any coffee powder!

•  Do not use this water for consumption.

Cleaning

 WARNING:

•  Before cleaning, always remove the mains plug and wait 

until the device has cooled down.

•  Do not immerse the device in water. Otherwise this might 

result in an electric shock or fire.

 CAUTIION: 

•  Do not use a wire brush or any abrasive items.

•  Do not use any acidic or abrasive detergents.

•  The exterior of the device should be cleaned as necessary 

with a slightly damp cloth – without any additives.

•  Remove spilled coffee grounds with a paper towel from the 

inner casing. Afterwards wipe with a damp cloth.

•  The coffee pot and the filter pad should be cleaned by rins-

ing in warm water. Use a soft brush if necessary.