Clatronic KA 3328 - Инструкция по эксплуатации - Страница 35

35

Supplied parts

1 x Automatic coffee maker  2 x Thermos flask

1 x Filter holder 

2 x Lid for the flask 

Unpacking the appliance

1.  Remove the appliance from its packaging.

2.  Remove all packaging materials such as films, filler mate

-

rial, cable clips and carton.

3.  Check the contents for completeness.

4.  In the event that the packaging content should be incom-

plete or if damages are noticeable, do not operate the 

appliance. Return it to the dealer immediately.

NOTE:

Production residue or dust may have collected on the appli-

ance. We recommend cleaning the appliance according to 

chapter “Cleaning”.

Instructions

Placement

•  Place the automatic coffee maker on a stable and level 

surface. Place the appliance in such way that it cannot tip 

over. 

•  Do not place the appliance in close proximity to a gas or 

electric stove or any other heat source.

Electric Connection

1.  Ensure that your mains power corresponds with the specifi

-

cations of the appliance. The specifications are printed on 

the type label.

2.  Connect the mains cable to a properly installed and earthed 

wall outlet.

Operation

Before making coffee for the first time operate the appliance 

twice with clean water only and without paper filter. This 

removes dust, which may have collected during transport. 

Operation

Preparing the Coffee Machine

1.  Open the lid of the water tank.

2.  Fill cold water according to the desired amount of cups of 

coffee into the rear water tank. The water level is displayed 

on the indicator.

NOTE:

You can use the pot to fill the water tank. 

CAUTION:

Do not overfill the tank! Do not fill it above the 8 mark.

3.  Screw the lid onto the flask so that the button on the lid 

points towards the handle.

4.  Ensure that the filter holder is properly attached.

5.  Turn over the lower fold of the paper filter (size 1x4) and 

place it in the filter funnel. Then fill it with coffee powder.

6.  Close the water reservoir lid until it audibly clicks into place 

7.  Set the flask with the screwed-on lid onto the hotplate. 

CAUTION: Drip stop

Your appliance comes with a drip stop. It closes when 

removing the coffee pot. This prevents the coffee from 

dripping onto the warming plate if there is still water in the 

filter.

•  Ensure that the lid is attached to the coffee pot.  

It opens the drip stop. 

•  If there is still water in the tank, place the pot under-

neath as soon as possible. Otherwise the filter might 

overflow.

8.  Turn on the appliance. The pilot lamp in the switch will be 

lit. 

The Coffee Is Ready

NOTE:

The brewing process lasts approximately. 10-15 minutes.

•  When no more coffee is flowing through the filter you can 

remove the pot. 

•  Turn the device off. The pilot lamp will go out. 

•  If you would like to pour coffee from the flask, press the 

button on the lid.

NOTE:

The filter holder can be removed from the machine by its 

handle. This makes it easier to dispose of the old coffee filter, 

for example.

WARNING:

If you would like to brew another flask of coffee right away, 

turn off the appliance. Let it cool down with the water reser-

voir open, to prevent hot splashes when refilling the water.

De-scaling

De-scaling is necessary when the brewing time increases 

substantially.
•  Use only commercially available citrus acidbased de-scaler. 

•  Follow the recommended instructions for use. 

WARNING:

•  Afterwards you should boil fresh water in the pot three or 

four times in order to rinse out residues of the descaling 

agent.

•  Do not use any coffee powder!

• Do 

not

 use this water for consumption.