Bosch TAS6507 - Инструкция по эксплуатации - Страница 15

11 en

Troubleshooting

The following table contains solutions to problems or faults which may occur  during 

operation of the appliance and that can be easily rectified at home. If you are not 

satisfied with the solutions provided here, please contact our Customer Service 

department. 

Further customer service information can also be found online: 

www.bosch-home.com  

www.tassimo.com

Problem

Cause

Solution

No LED is lit.

The appliance is in idle 

mode.

Press 

Start / Stop

 button.

The controls do not 

respond to touch.

Technical fault.

Unplug the mains plug. Wait for approx. 

5 minutes. Re­insert the mains plug into the 

socket.

The control panel is 

dirty.

Unplug the mains plug. Clean the display 

elements/controls with a soft, damp cloth. Re­

insert the mains plug into the socket.

The appliance is not 

working and none of 

the display elements 

are lighting.

The appliance has no 

power supply.

Check to see whether the appliance is 

connected to the mains.

The brewing starts, 

however there is no 

beverage dispensed.

The water tank is not 

inserted correctly.

Check that the water tank is correctly inserted. 

The water tank was 

removed during the 

brewing stage or there 

is air in the system.

Start the cleaning process with the orange 

Service T DISC. Please refer here to the section 

First Time Use

, Steps 2 – 14.

The float in the water 

tank is stuck.

Clean the water tank and free the float.

The brewing will not 

start.

No T DISC inserted.

Check that a T DISC has been inserted.

The appliance does 

not recognise the 

T DISC bar code.

The displays/buttons 

for drink intensity, 

drink temperature and 

drink size are flashing.

Clean the T DISC reading window with a soft, 

damp cloth.

Smooth out the foil of the T DISC with your 

finger so that the bar code can be read.

Use a new T DISC.

If the problem persists, contact the  TASSIMO 

careline.

The brewing unit is not 

closed properly.

Clean the brewing unit with a soft, damp cloth, 

paying particular attention to the lid area.

The appliance was not 

plugged in when the 

T DISC was inserted.

Check that the appliance is plugged into the 

power supply before inserting the T DISC.