BRAYER BR1120 - Инструкция по эксплуатации - Страница 4

6

7

en

en

• 

Do not leave children unattended to prevent using 

the unit as a toy.

• 

Do not allow children to touch the unit and the power 

cord during the coffee maker operation.

• 

Place the unit out of reach of children during the 

operation and cooling down.

• 

This unit is not intended for usage by physically or 

mentally disabled persons (including children) or

•  by persons lacking experience or knowledge if 

they are not under supervision of a person who 

is responsible for their safety or if they are not 

instructed by this person on the usage of the unit.

•  From time to time check the power cord and the 

power plug integrity.

• 

If the power cord is damaged, it should be replaced 

by the manufacturer, a maintenance service or 

similar qualified personnel to avoid danger.

• 

Do not repair the unit by yourself. Do not 

disassemble the unit by yourself, if any malfunction 

is detected, and after it was dropped, unplug the unit 

and apply to the service center.

•  Transport the coffee maker in the original package.

• 

Keep the unit out of reach of children and disabled 

persons.

COFFEE MAKER IS INTENDED FOR HOUSEHOLD 

USE ONLY, DO NOT USE THE COFFEE MAKER FOR 

COMMERCIAL OR LABORATORY PURPOSES.

BEFORE USING THE COFFEE MAKER

After unit transportation or storage at low 

temperature, it is necessary to keep it for at least 

three hours at room temperature.

•  Unpack the coffee maker and remove all the 

packaging materials. 

•  Keep the original package.

•  Check the delivery set.

• 

Read the safety measures and operating 

recommendations.

•  Examine the coffee maker for damages, in case of 

damage do not plug it into the mains.

•  Make sure that the specifications of power supply 

voltage specified on the lower panel of the unit 

correspond to the specifications of your mains. When 

the unit is used in the mains with 60 Hz frequency, it 

does not need any additional settings.

•  Wipe the surface of the coffee maker body with a 

clean, slightly damp cloth to remove dust. 

•  Turn the funnel, remove the filter holder (4) from the 

funnel, remove the reusable filter (5).

• 

Wash all removable parts in warm water with a 

neutral detergent: the coffee flask (1), the filter holder 

(4), the filter (5), rinse them and dry.

•  Install the filter holder (4) into the funnel.

•  Insert the filter (5) into the holder (4).

• 

Turn the funnel to the operating position.

•  Fill about one half of the coffee flask (1) with pure 

water.

•  Open the lid (6) and pour the water from the flask (1) 

to the water tank (7).

•  Close the lid (6) and put the flask (1) on the tray (10).

•  Insert the power plug into the mains socket. 

• 

Set the power switch (10) to the position“I” to switch 

the coffee maker on; the light indicator in the power 

switch (10) will light up.

•  After the water tank (7) is empty, switch the coffee 

maker off by setting the power switch (10) to the 

position «0», the light indicator will go out.

• 

Let the unit cool down for 5 minutes and pour the 

water out from the flask (1). 

• 

If necessary, repeat the washing cycle of the coffee 

maker 2-3 times.

MAKING COFFEE

Ready coffee is made by single passing of hot water 

through the layer of ground coffee in the filter (5). 

The taste of the drink depends on the quality of raw 

products, therefore we recommend using well-roasted 

and fresh-ground coffee beans.

• 

Turn the funnel, measure the required amount of 

ground coffee and put it into the filter (5). 6 grams 

of ground coffee per one coffee cup is required on 

average; adjust the amount according to your taste.

• 

Turn the funnel to the operating position.

•  Open the lid (6), fill the tank (7) with cold water up to 

the required level. Determine the water level using 

the scale (8).

• 

Close the lid (6).

•  Put the flask (1) on the tray (12).

•  Insert the power plug into the mains socket. 

• 

Set the power switch (10) to the position“I” to switch 

the coffee maker on; the light indicator in the power 

switch (10) will light up.

•  The flask (1) is filled with ready coffee, switch the 

coffee maker off by setting the power switch (10) to 

the position «0», the light indicator will go out.

•  To keep the coffee hot, leave the flask (1) on the tray 

(12) and do not switch the coffee maker off.

• 

Notes: 

the keep warm time for ready coffee is limited 

to 40 minutes, after that the coffee maker will switch 

off.

ATTENTION!

•  When you no longer need to heat the flask (1), 

switch the coffee maker off by setting the power 

switch (10) to the position «0».

• 

Water passes through ground coffee under steam 

pressure, so do not bend over the coffee maker, 

do not open the lid (6), do not turn the funnel and 

do not remove the filter holder (4) and the filter (5) 

during making coffee.

•  Do not leave the empty coffee flask (1) on the flask 

warming tray (12), otherwise the glass may crack.