Кофемашина Saeco SM6580/10 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
20
English
Problem
Cause
Solution
The machine is performing its self-
adjustment procedure. This
procedure is started automatically
when you use the machine for the
first time, when you change to
another type of coffee beans or
after a long period of non-use.
Brew 5 cups of coffee initially to allow the
machine to complete its self-adjustment
procedure.
The grinder is set to a too coarse
setting.
Set the grinder to a finer (lower) setting.
Brew 2 to 3 drinks to be able to taste the
full difference.
The coffee is not hot
enough.
The temperature is set too low.
Set the temperature to the maximum
setting (Fig. 52).
A cold cup reduces the
temperature of the drink.
Preheat the cups by rinsing them with hot
water.
Adding milk reduces the
temperature of the drink.
Regardless of whether you add hot or cold
milk, adding milk always reduces the
temperature of the coffee. Preheat the
cups by rinsing them with hot water.
Coffee does not come out
or coffee comes out
slowly.
The AquaClean water filter was
not prepared properly for
installation.
Remove the AquaClean filter and dispense
some hot water. If this works, the
AquaClean filter was not installed
properly. Reinstall and activate the
AquaClean filter and follow all steps in
chapter 'AquaClean water filter'.
After a long period of non-use, you need
to prepare the AquaClean water filter for
use again and dispense 2-3 cups of hot
water.
The AquaClean water filter is
clogged.
Replace the AquaClean water filter every 3
months. A filter that is older than 3
months can become clogged.
The grinder is set to a too fine
setting.
Set the grinder to a coarser (higher)
setting. Note that this will impact the
coffee taste.
The brew group is dirty.
Remove the brew group and rinse it under
the tap (see 'Cleaning the brew group
under the tap').
The coffee dispensing spout is
dirty.
Clean the coffee dispensing spout and its
holes with a pipe cleaner or needle.
The pre-ground coffee
compartment is clogged
Switch off the machine and remove the
brew group. Open the lid of the pre-
ground coffee compartment and insert
the spoon handle into it. Move the handle
up and down until the clogged ground
coffee falls down (Fig. 37).
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
