Кофемашина Krups EA 850B - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
18
Danger:
Only a qualified technician is authorised to perform repairs on the power cord and
the electrical network. If this instruction is not followed, you are at risk of death
due to electric shock! Never use an appliance that is visibly damaged!
MALFUNCTION
CORRECTIVE MEASURES
There is water under the ap-
pliance.
Before lifting off the tank, wait for 15 seconds after the coffee has run
through so that the appliance finishes its cycle correctly.
Check that the drip tray is correctly positioned on the appliance, it
must always be in place, even when your appliance is not being used.
Check that the drip tray is not full.
The drip tray must not be removed during a cycle.
When you turn off the ap-
pliance, hot water will come
out of the coffee nozzles and
the One Touch Cappuccino
block.
According to the type of recipe prepared, the appliance can carry
out an automatic rinsing operation when it is turned off. This cycle
lasts only a few seconds and stops automatically.
After emptying the coffee
grounds collector and clea-
ning the coffee drawer, the
warning message is still dis-
played.
Correctly refit the coffee drawer and the coffee grounds collector,
follow the instructions on the screen.
Wait at least for 8 seconds before refitting them.
The coffee comes out too
slowly.
When in operation, turn the grinding setting button to the right for
coarser coffee grounds (this can depend on the type of coffee used).
Perform one or several rinse cycles. Launch a clean programme
(see” Coffee circuit automatic cleaning programme" p.15).
Change the Claris Aqua Filter cartridge (see "Filter installation"
p.11).
After filling the water tank,
the warning message
remains on the screen.
Check that the tank is correctly positioned in the appliance.
Check and unblock the float if necessary. The float at the bottom
of the tank should move freely.
The grinding setting button
is difficult to turn.
Only change the grinding setting when in operation.
The espresso or coffee is
not hot enough.
Rinse the coffee circuit before starting to prepare your coffee.
Increase the temperature of the coffee in the Settings menu.
Heat the cup by rinsing with hot water before starting the prepa-
ration.
The coffee is too clear or
not coarse enough.
Do not use oily, caramelised or aromatised coffees.
Check that the bean tank contains coffee and that it descends
correctly.
Reduce the volume of the preparation, increase the strength of
the preparation.
When in operation, turn the grinding button to the left for finer
coffee grounds.
Prepare your coffee in two cycles using the two cup function.
No coffee is coming out of
the appliance.
An incident has been detected during the preparation.
The appliance is restarted automatically and is ready for a new
cycle.
There is a power cut
during the cycle.
The appliance restarts automatically when reconnected.
IFU_KR_EA85_EE_0A17616_EA85 09/09/13 17:51 Page18
