Кофемашина Siemens TK 52002 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
11
11
Switching on the appliance
● Pull enough of the power cord out of the
storage compartment and plug it into the
electrical socket.
● Remove and rinse the water tank
11
and fill it with fresh cold water. Do not fill
above the “max“ mark.
● Replace the water tank
11
and push it
firmly down into place.
● Fill the bean container with coffee beans.
● Set the power switch
1
to I. The standby
LED
a
lights red.
● Make sure that the hot water/steam dial
6
is at
O
.
● Press the standby button
a
. The
J
LED flashes.
Filling the system
When switched on for the first time, the
water pipes in the appliance must be filled.
● Place a cup under the nozzle
8
.
● Turn the dial
6
to
g
/
h
. Water runs into
the cup.
As soon as
J
lights up, turn the dial
6
back to
O
.
● The standby button
a
will now flash. The
appliance rinses and heats up.
The appliance is
ready for use
when the
standby LED
a
lights green.
i
The appliance’s factory settings are
programmed for optimal performance.
Controls
1 Power switch
The power switch
1
on the rear of the
appliance switches the power supply on
and off.
When the power is switched on, the
standby LED
a
lights red.
The appliance is now in standby mode.
Warning
Do not press the power switch while the
appliance is operating. The appliance
should only be switched off when it is in
stand-by mode.
Standby button
a
The standby button
a
switches the
appliance from standby mode to on.
When the standby button
a
is pressed, the
appliance heats up. The standby button
a
flashes while the appliance heats up and is
rinsed. When the standby button
a
lights
green, the appliance is ready for operation.
The appliance will not be rinsed if:
– it is still warm when switched on, or
– coffee was not dispensed before it was
switched to standby mode.
Note:
After 3 hours, the appliance
automatically switches to standby mode.
3 Coffee dispensing button
5
(mild coffee)
This button is used to dispense mild coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
4 Coffee dispensing button
K
(strong coffee)
This button is used to dispense strong
coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
5 Steam generation button
h
The steam button
h
generates steam for
foaming or warming.
6 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to
g
or
h
. To dispense
steam, the steam generation button
h
must be pressed first (see “Steam for
frothing milk“).
7 LED display
The various LEDs indicate the following:
H
on
The water tank is empty and
needs to be filled.
I
on
Trays full:
Empty and replace them.
I
flashing Trays missing:
Reinsert them.
en
en
