Siemens TE809201RW - Инструкция по эксплуатации - Страница 27

23

en

●

Press the 

start

 button 

8

. The appliance 

rinses twice.

Cleaning 

Open powder compartment

●

Open the powder compartment 

18

.

Insert Siemens cleaning tablet and 
close powder compartment

●

Drop a Siemens cleaning tablet in the 
drawer 

18

 and close.

Remove water filter ▶ start

Info: 

If the water ilter 

29

 is activated, the 

display will prompt you to remove the ilter 

29

, then press the 

start

 button 

8

 again.

Add 0.5 l water and descaler ▶ start

●

Pour lukewarm water into the empty 
water tank 

11

 up to the “

0.5 l

” mark and 

then dissolve two Siemens descaling 

tablets in it.

●

Press the 

start

 button 

8

. The  descaling 

programme now runs for about 

20 minutes.

Descaling

Not enough descaling fluid.  

Refill fluid ▶ start

Info: 

If there is not enough descaling solu-

tion in the water tank 

11

, the corresponding 

prompt is displayed. Pour in descaling solu

-

tion and press the 

start

 button 

8

 again.

Clean and refill water tank ▶ start

●

Rinse the water tank 

11

 and reill it with 

fresh water up to the “

max

” mark.

●

Press the 

start

 button 

8

. The descaling 

programme now runs for about 1 minute 

more, followed by the cleaning pro-

gramme for about 7 minutes, and rinses 

the appliance.

Descaling
Cleaning

Empty drip tray 

Replace drip tray

●

Empty the drip tray 

23 

and reinsert it.

Replace the ilter if one is being used. The 

appliance has completed descaling and 

cleaning and is ready for use again.

Important:

 Wipe down the appliance 

using a soft, damp cloth to immediately 

remove any descaler residue. Such residue 

can cause corrosion. New sponge cloths 

may contain salts. Salts can cause rust 

ilm on stainless steel and must therefore 

be washed out  thoroughly before use. 

 Thoroughly clean the suction pipe 

10d

 of 

the milk frother.

Note:

 If one of the service programmes 

is interrupted, e. g. by a power outage, 

 proceed as follows:

●

Rinse the water tank 

11

 and reill it with 

fresh water up to the “

max

” mark.

●

Press the 

start

 button 

8

. The cleaning 

programme now runs for about 3 minutes, 

and rinses the appliance.

Cleaning

Empty drip tray 

Replace drip tray

●

Empty the drip tray 

23 

and reinsert it.

The appliance is ready for use again.

TE809_1RW.indb   23

08.05.2013   14:32:39