Siemens TE809201RW - Инструкция по эксплуатации - Страница 20

16

en

Drink preparation with milk

The appliance must be ready for use.

●

Place the suction pipe 

10d

 of the milk 

frother 

10

 deep in the milk container 

26

.

●

Swivel the coffee outlet 

9

 to the 

right

 until 

it clicks into place.

●

Place the pre-warmed cup or glass under 
the coffee outlet 

9

 and milk frother 

10

. 

●

Select the required 

Caffe Latte

, 

Macchiato

, 

Cappuccino

 or 

My coffee

 by 

turning the rotary knob 

6

.

●

Open the powder compartment 

18

.

●

Pour in no more than 2 level measuring 
spoons 

14

 of ground coffee.

¡

Warning!

Do not use whole beans or instant coffee.

●

Close the powder compartment 

18

.

●

Press the 

start

 button 

8

. 

First milk is delivered into the cup or glass. 

Then the coffee is brewed and dispensed 

into the cup or glass.

Important:

 Dried milk residue is dificult 

to remove, so the milk frother 

10

must

 be 

cleaned with lukewarm water immediately 

after use (see “Cleaning the milk system”).

Note:

 Repeat the procedure for another 

cup of coffee / milk drink. If coffee is not 

dispensed within 90 seconds, the brewing 

chamber empties automatically to avoid an 

overlow. The appliance rinses. 

Preparing milk froth and 
warm milk

¡

Risk of burns!

The milk frother 

10

 gets very hot. After use, 

allow to cool down irst before touching.

The appliance must be ready for use.

●

Place the suction pipe 

10d

 of the milk 

frother 

10

 deep in the milk container 

26

. 

●

Place the pre-warmed cup or glass under 
the outlet of the milk frother 

10

. 

●

Select the required setting 

Milk froth

 or 

Warm milk

 by turning the rotary knob 

6

. 

●

Press the 

start

 button 

8

. 

Milk froth or warm milk lows from the outlet 

of the milk frother 

10

. 

Press the 

start

 button 

8

 again to cut the 

process short.

Info:

 When preparing warm milk, you may 

hear a whistling sound. This is caused by 

the milk frother for technical reasons.

Tip: 

For optimal milk froth quality, use cold 

milk with a fat content of at least 1.5 % if 

possible.

Important:

 Dried milk residue is dificult 

to remove, so the milk frother 

must

 be 

cleaned with lukewarm water immediately 

after use (see “Cleaning the milk system”).

TE809_1RW.indb   16

08.05.2013   14:32:35