CONDTROL XLiner Pento 360 - Инструкция по эксплуатации - Страница 3

user manual

C ROS S 

L INE L A SER

EN

user manual

C ROS S 

L INE L A SER

EN

XLiner Pento 360/360G

XLiner Pento 360/360G

4

5

Congratulations on your purchase of the laser level XLiner Pento 360/

Pento 360G CONDTROL. Safety instructions can be found in the end 

of this user manual and should be carefully read before you use the 

device for the first time.

SAFE T Y IN S T RUC T I ON S 

Attention!

 This user manual is an essential part of this product.

The user manual should be read carefully before you use the product 

for the first time. If the product is given to someone for temporary 

use, be sure to enclose user manual to it.

- Do not misuse the product  

- Do not remove warning signs and protect them from abrasion, 

because they contain information about safe operation of the 

product.

- Do not look into the laser beam or its reflection, with unprotected 

eye or through an optical device. Do not point the laser beam at 

people or animals without the need. You can dazzle them.

- To protect your eyes close them or look aside.

- Always install the product in such a way, so that laser line is below 

or above eye level.  

- Do not let unauthorized people enter the zone of product operation. 

- Store the product beyond reach of children and unauthorized 

people.  

- Do not disassemble or repair the product yourself. Entrust product 

repair to qualified personnel and use original spare parts only.

- Do not use the product in explosive environment, close to flammable 

materials.

LASER RADIATION! 

Do not stareinto beam

Class 2 laser

<1 mW, 635/515 nm 

IEC 60825-1: 2007-03

- Laser intensive glasses are used for better recognition of the laser 

beam; do not use them for other purposes. Laser glasses do not 

protect from laser radiation as well as ultraviolet radiation and reduce 

color perception.

- Avoid heating the battery to avoid the risk of explosion and 

electrolyte leakage. In case of liquid contact with skin, wash it 

immediately with soap and water. In case of contact with eyes, flush 

with clean water during 10 minutes and consult the doctor.

PRODUCT DESCRIPTION

Cross line lasers XLiner Pento 360/Pento 360G CONDTROL are 

intended to project vertical and horizontal planes and lines as well as 

the laser dot (zenith and nadir). The laser levels are suitable for use at 

both indoor and outdoor building areas.
The cross line laser has 2 operating modes:

-  Automatic leveling to compensate irregularities within self-

leveling range of ± 3.5°;
-  Locked compensator, to project inclined planes and lines.

Pulse mode allows using laser receiver to increase the working range 

of the laser level or to work when laser is hard to define in bright 

lighting conditions.