ADA Cube 3D Professional Edition - Инструкция по эксплуатации - Страница 4

4

English

CHANGE OF BATTERIES

Open battery compartment. Insert batteries. Take care to correct polarity. 
Close battery compartment. ATTENTION: If you are not going to use instru-
ment for a long time, take out batteries.

OPERATION

Cube 3D is a reliable and convenient line laser. It will  be irreplaceable line 
laser for many years. Place the line laser on the working surface or mount 
it on the tripod/pillar or wall mount. Switch on the line laser. Visual alarm 
(blinking line) and audible signal indicate that the device was not installed 
within the compensation range ± 3º. To properly work align the unit in a hor-
izontal plane. Turn the compensator switch (3) to the position “ON” (the line 

laser  is turned off in the position OFF). At that compensator of the line laser  

will be in free position (it will be blocked in the position OFF). When switching 
on, one horizontal and one vertical lines will be projected. Press button (6) 
to turn on additional vertical line. Press button (6) again to have only one 

additional vertical line. Press button (6) one more time to turn off additional 

vertical line and switch on horizontal line. 

Use the receiver (supplied separately) mode to enlarge the working mode 
and for the operation in bright illumination. Press and hold button (6) for 
more than 2 sec to switch on the receiver mode. The mode is activated after 
the sound alarm. Press and hold button (6) for more than 2 sec again to 

switch off the receiver mode.

         TO CHECK THE ACCURACY OF LINE LASER (SLOPE OF PLANE)

Set up the line laser between two walls, the distance is 5m.Turn on the line 
laser and mark the point of cross laser line on the wall. Set up the line laser  
0,5-0,7m away from the wall and make, as described above, the same mas-

rks. If the difference {a1-b2} and {b1-b2} is less then the value of

3