ADA Cosmo 120 Video - Инструкция по эксплуатации - Страница 4

4

COSMO

 120

VIDEO

11. Additional calculations

12. Main result

Display in Digital Camera mode (3x magnification)

Built-in digital camera shows the target directly on the 

display.

The instrument takes measurements with the help of 

crosshairs, even if the laser dot is not visible (in bright 

illumination). 

3x magnification. Press the key to activate the magnification 

function. Press the key again to magnificate the image in 

one, two or three times.

The brightness of the display can be adjusted with      and 

buttons.

When the digital camera is used for close targets (<10m) the 

laser dot may not coincide with the image in the center of 

the display. In this case you should rely on the actual laser 

dot for targeting the object.

Inserting / Replacing Batteries

Remove the battery compartment lid.

Insert the batteries. Pay attention to the polarity.

Close the battery compartment.

The batteries should be replaced, when the battery voltage 

is too low.

Batteries should be removed if the device will not be used 

for a long time (danger of corrosion).

Use alkaline or Li-batteries.

NOTE:

We reccomend to use LI /IRON Batteries (energy-plus bat-

tery). Approximate time of continious operation*:

• LI / IRON (4 000 mAh) - about 5 hours

• NiMh (2 000 mAh) - about 3.5 hours

*in condition of operation under environment temperature 

20°C and also average values of instrument settings (bright-

ness, contrast and so on).

Laser classification

The instrument is a laser class 2 laser product with power    

< 1 mW and wavelength 635 nm. Laser is safety in ordinary 

conditions of usage.

End-piece

Fold out the end-piece (180°) to measure from the edge of 

the positioning bracket.