Legrand KEOR PDU 800 ВА 8 IEC - Инструкция по эксплуатации - Страница 24

24

4.2 

Start-up procedure

4.2.1 Normal mode

1. Ensure that the mains power supply to be used has a suitable voltage/frequency and an up-

stream protection rated at either 10A or 16 A.

2. Plug the UPS power cord into the mains power supply socket.

3. The UPS recharges its battery each time it is connected to a mains power supply (even if it is 

powered down). In this stand-by condition, it is also possible to use the USB charger port. It is 

recommended to charge the battery at least 4 hours before connecting the loads.

4. Connect the loads to the output sockets.

5. Press the ON/OFF button to start-up the UPS and power the loads.

INDICATION

The UPS has the autorestart function. In case the mains power fail and the UPS reaches the end of 

the back-up time, the load is powered automatically when the mains power is back.

4.2.2 Cold start

1. Make sure the internal battery is fully charged. 

2. Connect the loads in the back-up sockets.

3. Press the ON/OFF button to start-up the UPS and power the loads.

INDICATION

The output frequency is set to 50 Hz.

4.3 

Shutdown

1. Press and hold the ON/OFF button.

2. The UPS stops powering the back-up outlets.

3. Unplug the UPS from the mains power supply socket.

4  Operation