Smeg FL144P - Инструкция по эксплуатации - Страница 3

Instructions for Use

10

Description of the Appliance

Shelf (1)

The shelf may be placed randomly upon any of the guide slots
within the interior of the appliance. It is protected against
sliding out.

The shelf is placed upon the top four guides by lowering the
front section of the shelf downwards, the rear of the shelf is
placed upon the guide slot and the shelf is inserted in the guide
in the inclined position.
The shelf is placed upon the top four guides by lifting the front
section of the shelf upwards, the rear of the shelf is placed
upon the guide slot and the shelf is inserted in the guide in the
inclined position.

In case you may wish to remove the shelf from the appliance
lift the shelf by hand at the rear and pull it out in the opposite
procedure.
Glass shelves are  protected with plastic edge frames.
Quickly perishable food should be stored on the back i.e. the
coldest part of the shelves.

Defrost Water Outlet (2)

The interior of the refrigerator is cooled with cooling plate
incorporated in the rear wall. Under the plate there is a channel
and an outlet for defrost water.
Regularly check the defrost water outlet and the channel,
because they should never be clogged (as for example with
food rests). If clogged, use a plastic straw and clean it.

Crisp tray and serving tray (3)

The tray at the bottom of the refrigerator is covered with the
serving tray. This cover protects the stored fruit and vegetables
from excessive drying.

Door Liner

The door liner consists of various shelves or holders used for
storing eggs, cheese, butter and yogurt as well as other
smaller packages, tubes, cans etc.
The lower shelf is used for storing bottles.

Illumination in the Interior of the Refrigerator

The light for illuminating the interior of the appliance is on,
when the door is opened. The operation of the light does not
depend on the position of the thermostat knob.

Operation Control

The appliance is controlled with thermostat knob, situated in
the right upper part inside the appliance.
Turn the knob from 

STOP (0)

 position towards 

7

 and

backwards.

Temperature Selection

x

Higher settings on the knob (towards 

7

) mean lower

temperatures (colder) in all three compartments of the
appliance. Temperature in the interior of the appliance may
even drop below 0°C. Higher settings should be used only in
case higher temperature is recommended or required.
When the ambient temperature is normal, we recommend
medium setting.

x

Changes of the ambient temprature affect temperature in the
interior of the appliance (choose correct setting of the
thermostat knob).

x

In

STOP (0)

 position the appliance does not operate (the

cooling system is switched off), yet power supply is not
interrupted (the light is on, when you open the refrigerator
door).

x

Temperature in the refrigerator also depends on how often
the door is opened.