Smeg FAB30RAZ1 - Инструкция по эксплуатации - Страница 19

Installation

41

EN

5 Installation

5.1 Electrical connection

General information

•   Check the grid characteristics against the 

data indicated on the plate. The 
identification plate bearing the technical 
data, serial number and brand name is 
visibly positioned inside the appliance. 
Do not remove this plate for any reason.

•  Make sure that the plug and socket are 

of the same type.

•  Avoid using adapters and shunts as 

these could cause overheating and a risk 
of burns.

•  The plug must always be accessible 

when the appliance is installed.

•  Leave the refrigerator standing vertically 

for at least two hours before turning it on 
for the first time.

•  If it is necessary to replace the power 

cable, 

this must be performed by an 

authorised technician from Technical 
Support Service.

5.2 Positioning

Power voltage

Danger of electrocution

•  The appliance must be connected to 

earth in compliance with electrical 
system safety standards.

•  Do not pull the cable to remove the 

plug.

Heavy appliance

Danger of crush injuries

•  Position the appliance with the aid of a 

second person.

Pressure on the open door

Risk of damages to the appliance

•  Never use the open door to lever the 

appliance into place when fitting.

•  Avoid exerting too much pressure on the 

oven door when open.

•  The appliance must not be exposed to 

direct sunlight.

•  The appliance must not be installed near 

heat sources. If this is not possible, 
suitable insulation must be used.

•  Do not use the appliance outdoors.