Liebherr GX 821 Comfort - Инструкция по эксплуатации - Страница 3

Switching the appliance on and off

You are recommended to clean the appliance before switching 

it on for the first time (see "

Cleaning

"). Switch the appliance on 

4 hours before loading it with frozen food for the first time. 

Off:

 Using a coin, turn the arrow on the temperature control 

1

 to a setting between "1" und "6".

– The green ON-LED 

2

 is lit.

– The red warning-LED  

3

 twinkle up.

– The red warning-LED  is unlit as soon as the freezer com-

partment is cold enough (see "Red warning-LED"). 

To switch the appliance off:

 Turn the arrow on the tempera-

ture control 

1

 to "0". The visual control-LED are unlit.

Setting the temperature

Setting "1" = lowest cooling setting, warm

Setting "6" = highest cooling setting, cold

•

We recommend a 

medium

 setting.

•

If you are storing frozen food and wish to ensure that the 

low freezing temperature is maintained, we recommend 

setting the temperature control to between "4" and "6".

• For long-term storage of frozen food a temperature of at least 

-18°C is recommended. Remember that the temperature 

depends  on  the  ambient  temperature  (location  of  appli-

ance),  the  number  of  times  the  door  is  opened  and  how 

much frozen food is stored. The setting should be adjusted 

accordingly if necessary.

Dimensions 

(mm)

Connecting to the mains

Power supply (a.c.) and voltage at the operating point must 

comply with the details on the type plate which is located on the 

left-hand inside wall, next to the top freezer drawer. The socket must 

be fused with a 10 A fuse or higher. The socket should be easily 

accessible and not directly behind the appliance. 

• Do not connect the appliance to the supply with other equip-

ment using a distribution outlet - risk of overheating.

• Connect the appliance through a properly earthed plug 

and socket. 

Setting up

•  The floor on which the appliance stands should be horizontal 

and level. To compensate for any unevenness, adjust the 

height of the feet with an open-ended wrench. The appliance 

can be placed with its back flush to the wall.

•  Always position the appliance directly up against the wall.

•  The ventilation grilles should not be obstructed.

•  Condensation may form on the outside of the refrigerator/freez-

er during periods of high humidity. 

   Constant ventilation of the installation site is recommend.

•  Do not place heat-emitting appliances, e.g. microwave oven, 

toaster, etc., on top of the freezer.

•

In order to avoid the risk of fire, do not place any burning candles, 

lamps or other objects with open flames on the refrigerator/freezer.  

•  Standard EN 378 specifies that the room in which you install 

your appliance must have a volume of 1 m

3

 per 8 g of R 600a 

refrigerant used in the appliance, so as to avoid the formation 

of inflammable gas/air mixtures in the room where the appli-

ance is located in the event of a leak in the refrigerant circuit. 

   The quantity of refrigerant used in your appliance is indicated 

   on the type plate on the inside of the appliance.

•  Fire hazard due to dampness!

    If live parts or the mains lead become damp this may cause 

short circuits.

-  The appliance is designed for use in enclosed areas. Do not 

operate the appliance outdoors or in areas where it is exposed 

to splash water or damp conditions.

• CAUTION! Risk of injury and danger of damage as a result of 

incorrect transport!

- Transport the appliance in a packed condition.

- Transport the appliance upright.

- Do not transport the appliance without assistance.

The red visual warning LED

The red alarm LED 

3

always lights up when the appliance 

is put into operation.  A flashing alarm LED indicates that the 

temperature has risen too high.

If  the  red  warning-LED  comes  on  during  normal  operation, 

check:

– whether there has been a lengthy interruption to the power 

supply; check the quality of the frozen food and prepare for 

consumption if necessary,

– whether the door is properly shut,

– whether fresh food has recently been inserted. 
If  none  of  the  above  apply,  consult  your  nearest  customer 

service department as soon as possible, giving details of the 

appliance designation

, 

service number 

and 

appliance 

number 

.

A

                 h         a         g         e         e'         d         c        c'     

 G 1221   851     553     611     624      653    1129     563    592

 GX 821   631     553     611     624      653    1129     563    592

Saving energy 

-  Always ensure good ventilation. Do not cover ventilation open-

ings or grille.

-  Do not place appliance in areas of direct sunlight or next to a 

stove, heater or similar object.

-  The energy consumption depends on the installation condi-

tions, e.g. the ambient temperature.

-  Keep the time the appliance is open to a minimum. 

-  Store food logically.

-  Ensure that all food is well packed and covered for storage.

  This will prevent frost from forming.

-  First cool warm food to room temperature before storing it.

-  If there is a thick layer of frost in the ap-

pliance: defrost the appliance.

Accumulated dust increases the energy 

consumption: 

-  Once a year, dust the refrigerating unit 

together with the metal grille of the heat 

exchanger at the back of the appliance.