Liebherr GPesf 1466 Premium SuperFrost - Инструкция по эксплуатации - Страница 3

7

Control elements

Temperature display

The temperature display indicates the highest tem-

perature in the freezer. The display is designed so that 

only temperatures below 0°C are displayed.

Temperature alarm

If the temperature display is flashing, this indicates that the temper-

ature has risen too high. The audible warning signal will sound at 

the same time. Press the 

"ALARM"

 button to switch the signal off.

When the temperature drops again and reaches about -13 °C, 

the temperature display will stop flashing and will light constantly.

If 

F4

 or 

F5

 appears in the display, the appliance has a fault. It 

will be kept at the right temperature by means of a safety circuit. 

Consult your nearest customer service point.

Setting up

•  The floor on which the appliance stands should be horizontal 

and level. To compensate for any unevenness, adjust the 

height of the feet with the open-ended wrench supplied.

•  Always position the appliance directly up against the wall.

•  The ventilation grilles should not be obstructed.

•  Condensation may form on the outside of the refrigerator/freez-

er during periods of high humidity. Constant ventilation of the 

installation site is recommend.

•  Do not place heat-emitting appliances, e.g. microwave oven, 

toaster, etc., on top of the freezer.

•  Keep burning candles, lamps and other items with naked 

flames away from the appliance so that they do not set the 

appliance on fire.

•  Standard EN 378 specifies that the room in which you install 

your appliance must have a volume of 1 m

3

 per 8 g of R 00a 

  refrigerant used in the appliance, so as to avoid the formation 

of inflammable gas/air mixtures in the room where the 

appliance is located in the event of a leak in the refrigerant 

circuit. The quantity of refrigerant used in your appliance is 

indicated on the type plate on the inside of the appliance.

•

Fire hazard due to dampness!

   If live parts or the mains lead become damp this may cause 

short circuits.

-  The appliance is designed for use in enclosed areas. Do not 

operate the appliance outdoors or in areas where it is exposed 

to splash water or damp conditions.

•  CAUTION! Risk of injury and danger of damage as a result of 

incorrect transport!

-  Transport the appliance in a packed condition.

-  Transport the appliance upright.

-  Do not transport the appliance without assistance.

•  The appliance may be moved only when it is empty.

Connecting to the mains

Power supply (a.c.) and voltage at the operating point must 

comply with the details on the type plate, which is located in the 

freezerr compartment on the left-hand side. The socket must be 

fused with a 10 A fuse or higher, it must be away from the rear of 

the appliance and must be easily accessible.

•  Do not connect the appliance to the supply with other equip-

ment using a distribution outlet - risk of overheating.

• 

Connect the appliance with a properly earthed fused plug 

and socket only.

The wires in the mains lead are coloured in accordance with the 

following code: green/yellow = earth, blue = neutral, brown = live. 

Warning! This appliance must be earthed.

Switching the appliance on and off

You are recommended to clean the appliance before switching 

it on for the first time (see "

Cleaning

"). Connect the appliance 

to the mains - the appliance is switched on.

-  The two illuminated dashes of the digital temperature display 

will light up until a temperature of 0°C is reached.

-  If the temperature is below 0°C, the digital temperature display 

will show the temperature inside the appliance.

•  To switch the appliance off:

 Press the 

ON/OFF

 button so 

that the temperature display goes dark.

•  To switch the appliance on:

 Press the 

ON/OFF

 button 

until the temperature display lights up.

Setting the temperature

The appliance is pre-set for normal operation (-18°C).

• To increase the temperature:

  Press the top button.

• To reduce the temperature:

  Press the bottom button.

-  While you are entering the temperature, the set temperature will 

flash on the display.

-  You can change the settings in increments of 1°C briefly press-

ing the button again. If the buttons are held down the tempera-

ture setting will change faster.

-  The electronic controls will switch over automatically about 5 

seconds after the last time you pressed the button, and the 

actual temperature in the freezer will be displayed.

Control elements

The "SUPERFROST" lamp

lights up when the 

"SUPERFROST"

 facility is switched on 

for freezing large quantities of fresh food (see "Freezing"). 

Power failure "frost-control" display

If 

nA

 appears in the display, this means that the freezer tempera-

ture has risen too high during the last few hours or 

days due to a power failure.

If you press the 

"ALARM"

 button whilst the display is 

read

ing

nA

, the highest temperature registered during 

the power failure will be displayed. Check the quality of the 

food and its suitability for consumption in case it has become 

too warm or even defrosted.

The highest temperature will appear for appox. 1 minute. After that, 

the actual temperature in the freezer will re-appear. The display 

can be switched off by repeatedly pressing the 

"ALARM"

 button.

Audible warning signal

The audible warning device helps to protect the frozen food and 

to save energy.

-  It sounds when it is not cold enough in the freezer compart-

ment. The temperature display will also flash;

-  when too much warm air from the outside enters when insert-

ing, re-arranging or removing frozen food.

The audible warning device is switched off by pressing the

"ALARM" 

button. The temperature display will continue to 

flash until the cause of the alarm has been rectified.

                       h        a         g         e         e'         d          c        c'      

GP 13       851     553      11     24      53     1129     53    592
GP 14       851     02      11     28      57     1174     13    40

GPesf 14   851     02      11     10      57     1174     597    44

Dimensions 

(mm)

GB