Kraft TNC-NF301W - Инструкция по эксплуатации - Страница 37

36

ХОЛОДИЛЬНИК 

REFRIGERATOR FREEZER

ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE

   •  After everything is dry place appliance back into service.

TROUBLESHOOTING

Before troubleshooting, disconnect the power supply. Only a qualified electrician of 

competent person must do the troubleshooting that is not in this manual.

Important!

  There  are  some  sounds  during  normal  use  (compressor,  refrigerant 

circulation).

If the malfunction shows again, contact the Service Center. These data are necessary 

to help you quickly and correctly. Write the necessary data here, refer to the rating plate.

Problem

Possible cause

Solution

Appliance dose not work

Mains plug is not plugged in or is 
loose

Insert mains plug

Fuse has blown or is defective

Check fuse, replace if necessary

Socket is defective

Mains malfunctions are to be corrected by 
an electrician

Appliance freezes or cools 
too much

Temperature is set too cold or the 
appliance runs at 

SUPER 

modes

Turn the temperature regulator to a 
warmer setting temporarily

The food is not frozen 
enough

Temperature is not properly adjusted

Please look in the initial Temperature 
Setting section

Door was open for an extended 
period

Open the door only as long as necessary

A large quantity of warm food was 
placed in the appliance within the last 
24 hours

Turn the temperature regulation to a colder 
setting temporarily

The appliance is near a heat source

Please look in the installation location 
section

Heavy build up of frost on 
the door seal

Door seal is not air tight

Carefully warm the leaking sections of 
the door seal with a hair dryer (on a cool 
setting). At the same time shape the 
warmed door seal by hand such that it sits 
correctly

Unusual noises

Appliance is not level

Re-adjust the feet

The appliance is touching the wall or 
other objects

Move the appliance slightly

A component, e.g. a pipe, on the rear 
of the appliance is touching another 
part of the appliance or the wall

If necessary, carefully bend the component 
out of the way