Jacky`s JR FV570EN - Инструкция по эксплуатации - Страница 33

EN -32-

• When  removing  ice  from  the  ice-making  compartment,  do  not  touch  it.  Ice 

may cause frost burns and/or cuts.

• Do not touch frozen goods with wet hands. Do not eat ice-cream or ice cubes 

immediately after you have taken them out of the ice-making compartment.

• Do  not  re-freeze  frozen  goods  after  they  have  melted. This  may  cause  health  issues 

such as food poisoning.

• Do not cover the body or top of fridge with lace. This affects the performance of your 

fridge.

• Secure  any  accessories  in  the  fridge  during  transportation  to  prevent  damage  to  the 

accessories.

• Do not use plug adapter.

Installing and operating your fridge freezer

Before starting to use your fridge freezer, you should pay attention to the following points:

• The operating voltage for your fridge freezer is 220-240 V at 50Hz.

• We do not accept responsibility for any damages that occur due to ungrounded usage.

• Place your fridge freezer where it will not be exposed to direct sunlight.

• Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores, 

and at least 5 cm away from electrical ovens.

• Your fridge freezer should never be used outdoors or exposed to rain.

• When your fridge freezer is placed next to a deep freezer, there should be at least 2 cm 

between them to prevent humidity forming on the outer surface.

• Do not place anything on your fridge freezer, and install your fridge freezer 

in a suitable place so that at least 15 cm of free space is available above it.

• Do not place heavy items on the appliance.

• Use the adjustable levelling feet to make sure your appliance is level and 

stable. You can adjust the levelling feets by turning them in either direction. 

This should be done before placing food in the fridge freezer.

• Before  using  your  fridge  freezer,  wipe  all  parts  with  a  solution  of  warm  water  and  a 

teaspoon of sodium bicarbonate, then rinse with clean water and dry. Place all parts in 

the fridge after cleaning.

If your refrigerator has a fan condenser: 

The condenser of your fridge is placed at the bottom of cabinet. As a result of that, assemble 

the spacer by fixing it to holes on the cover bottom panel and turn 90° that’s shown below 

figure  for  arranging  the  distance  between  the  refrigerator  and  the  back  wall  at  where  you 

place the fridge. You can move the fridge towards the back wall until that point.

Plastic for distance setting