Sub-Zero ICBIC-30RID-LH - Инструкция по эксплуатации - Страница 5

subzero.com   

|

   5

Freezer Storage

FREEZER BASKETS

To remove, pull forward until basket stops. Pull the two 
plastic tabs located behind the bottom two corners of the 
basket forward, then lift up and out. Refer to the illustration 
below. To reinstall, push drawer slides in. Align the basket 
with slides and push back until it stops. Press down on the 
front of the basket to engage slides. Refer to the illustration 
below.

If door opening is limited to 90°, the top basket must be 
removed before removing the middle or lower basket.

ICE CONTAINER

Column  

|

  To remove ice container, pull freezer drawer open 

until it stops and lift container out. To reinstall, pull drawer 
carrier out and align the bottom of the container with the 
carrier. Refer to the illustration below.

Tall and drawer  

|

  To remove ice container, pull freezer 

drawer open until it stops and lift container out. To reinstall, 
place in the drawer with tabs on the bottom of the container 
aligned with slots in the drawer. Refer to the illustration 
below.

The ice maker must be turned off by touching 

 when 

the ice storage container is removed. The unit is equipped 
with a 3-minute delay after the ice container is removed, to 
ensure cubes are not ejected before ice maker can be deac-
tivated or ice container is reinstalled.

 
Freezer basket removal.

 
Column ice container.

 
Tall and drawer ice container.

DRAWER REMOVAL

To remove, pull open until drawer stops. Raise the drawer 
front and pull out drawer. To reinstall, raise the front of 
drawer and place onto the slides. Align the back of the 
drawer with hooks on the slide, then align the white pegs 
at the front of the slide with holes at the front of the drawer. 
Refer to the illustration below.

IMPORTANT NOTE:

 For drawer models, the upper drawer 

has a control cable that must be disconnected before 
removing the drawer. Refer to the illustration below.

Storage Drawers

CRISPER COVER

The crisper cover in the upper storage drawer can be slid 
closed or left open.

To remove, pull the upper drawer all the way out, raise the 
front edge of the crisper cover and pull it forward out of the 
drawer. Refer to the illustration below. 

DRAWER DIVIDERS

To remove or adjust a short divider, flex the long divider 
slightly, then pull upward. Refer to the illustration below.

To remove a long divider, the short dividers must be 
removed. Pull divider up until it stops, rotate counterclock-
wise, then pull upward. To reinstall, align grooves with 
drawer tabs, rotate clockwise, then slide down.

 
Crisper cover.

 
Drawer dividers.

 
Drawer removal.

 
Control cable (drawers).

STORAGE