Fulgor Milano FRSI 401 FED X - Инструкция по эксплуатации - Страница 17

1168

17

Using the appliance

EN

CONTROL PANEL  

1 ON/OFF

2  TEMPERATURE ADJUSTMENT 

       Up 

       Down

3  DISPLAY SCREEN

4  DOOR OPEN ALARM ON DISPLAY

5  SUPER FUNCTION

6  HOLIDAY FUNCTION 

IMPORTANT WARNING

Whenever the product has been lying horizontally during 

transportation, it should be left to stand upright for at 

least six hours before it is switched on, otherwise it may 

be noisy when it is in operation.

NOTE: Before inserting the plug into the electri-

cal socket, ensure that the line voltage corresponds 

with that indicated in the product data plate. Connect 

the socket to the mains. Do not use adapters or 

extension leads, as these may overheat and burn.

SWITCHING ON THE APPLIANCE

Open the door. The refrigerator starts by pressing the 

1 ON/OFF button for at least 0.5 seconds, followed by 

an acoustic signal (1 BEEP): the display shows the 

temperature set in the refrigerator compartment and 

flashes for 6 seconds, then the actual temperature of the 

compartment appears. The display shows a temperature 

range between 0 and +20°C. If a temperature higher 

than +20°C is detected, the display (3) will show the 

“H” symbol (steady light). After 30 seconds the appli-

ance starts operating. The appliance shutdown occurs 

by pressing the 1 ON/OFF button for at least 5 seconds, 

followed by an acoustic signal (2 BEEP). At this point 

the display is off. 

SETTING THE TEMPERATURE

The appliance has a standard setting suitable for normal 

mode operation.  

The temperature can be set between +2 °C and +7 °C. The 

temperature is set by pressing the 2 UP/DOWN symbols, 

UP for higher values and DOWN for lower values. Upon 

starting the appliance, the display (3) shows the actual 

temperature; it varies one degree at a time whenever 

the  2 UP/DOWN symbols are slightly pressed; during 

temperature setting, the displayed value flashes. About 

5 seconds after the last symbol has been pressed, the 

actual temperature is displayed. The temperature slowly 

reaches the set value. 

NOTE:

•   The distance between the shelves and the rear internal 

wall of the refrigerator ensures that air circulates freely.

•   Do not place food in direct contact with the rear wall 

of the refrigerator compartment.

•   Do not place food that is still warm into the compart-

ments.

•   Keep all liquids in closed containers.