Fhiaba KS8990TST3 - Инструкция по эксплуатации - Страница 21

47

12

12.1

www.fhiaba.com ∙ info@fhiaba.com ∙ Tel +39 (0)434 420160 ∙ Fax +39 (0)434 420161

EN

Troubleshooting Guide

Troubleshooting Guide

Did you leave the doors open for a long period of time?
Do the doors close perfectly?
If the doors do not close perfectly, contact your installer.
In case of frost or ice build up in the Crisper-Fresco com-
partment, due to frequent and prolonged opening of the 
doors, deactivate the Crisper-Fresco function via the but-
ton on the control panel. Wait until the frost or ice melt, 
then remove the drawer and dry the sides and bottom of 
the compartment. 

Clean the appliance completely according to the instruc-
tions.
Hermetically cover all the food. Do not conserve food for 
prolonged periods of time.

The appliance is designed to ensure a fully hermetic clo-
sure. When the door is closed, a vacuum condition can 
occur: in this case it is necessary to wait a few seconds until 
the pressure balances before opening the door.

Check to see if the appliance was accidently placed into 
Sabbath Mode

Ice or frost build up inside the refrigerator

or freezer

Unpleasant odors inside the refrigerator

The doors are difficult to open

Appliance is cooling but lights and display 

are not working

If you notice malfunctions in your appliance, use this guide 
before calling for service: this guide can help you person-
ally resolve the problem or could provide important infor-
mation to be conveyed to the service technician to ensure 
rapid and effective repair.

A malfunction is usually indicated by a message on the 
display.
Problems that cannot be solved by the user are signaled 
through a malfunction code.

Is the appliance connected to the electrical power supply?
Is electrical power available at the electricity socket?
Is the Unit button   activated?
Is the unit in ‘Demo’ Mode?

Does the display show a malfunction code?
Is the temperature adjusted correctly?
Were the doors or drawers open for a long period of time?
Were large quantities of food recently inserted?
Is the unit in ‘Demo’ Mode?

Bear in mind that during very hot weather and with very 
high temperatures in the room it is normal that the com-
pressor remains on for prolonged periods of time. 
Were the doors or drawers open for a long period of time?
Were large quantities of food recently inserted?
Check that the doors are closed and that the food or con-
tainers do not obstruct the perfect closure of the door.
Is one or more compartments in Shopping Mode?

It is normal to hear noises from the ventilators or compres-
sors during operation or during the defrost phase. 
Noise could be more marked depending on the position of 
the appliance and the surrounding environment.

If the climate is very humid, the formation of condensation 
is normal.Opening the door or drawers for prolonged peri-
ods of time can contribute to the formation of condensa-
tion.
In any case, make sure that the doors are always perfectly 
closed.

Malfunction message

The refrigerator or the freezer does not work

The refrigerator or the freezer 

is warmer than usual

The appliance remains in function 

for a long time period

If you hear unusual noises

Condensation inside and outside 

of the refrigerator

On average, the Ice Maker produces approximately 10 
cubes of ice every two and half hours.

When  the  Ice  Maker  is  started  for  the  first  time,  it  is  recom-
mended to empty the first full tray of ice cubes.
If the refrigerator was switched off for more than one month or 
if the cartridge was not changed for more than six months, it 
could be necessary to replace the filter cartridge.
Contact a plumber or a water treatment expert to make sure 
that the problem is not due to the water supply.

If the ice is not used frequently, it is possible that blocks of 
ice may form. It is recommended to remove the block of ice 
cubes and then let the Ice Maker fill the ice tray again. 

Make sure that the Ice Maker is on (Icemaker button   on).
To switch on the Ice Maker press the button.
Make sure that the appliance is connected to the water sup-
ply.

The Ice Maker does not produce

sufficient amounts of ice

The ice has an unusual flavour or colour

If the unit you purchased was used as a showroom model it 

may be in a special energy-saving mode called Demo Mode 

where the appliance appears to be operating (lights work 

and false temperatures are displayed) but no cooling actu-

ally takes place.  If you suspect your appliance is in Demo 

Mode please contact your point of purchase for assistance 

with disabling this feature.

The ice cubes freeze into one block

The Ice Maker does not work